Furnace Repair in Overland Park, KS
Furnaces here run from October through April. If yours quits, tell us what it's doing and a licensed contractor who covers Johnson County will get in touch.
Tell us about the job
It takes about a minute.
Seven months of heat wears on your furnace
October through April, your furnace is what keeps the house warm on nights that average 23°F. That is seven months of the burner lighting and shutting off, over and over, and each cycle puts a little more wear on the igniter and the sensor that tells it the flame caught. Almost seven in ten homes here heat with gas, so when one of those parts finally gives out, the furnace does not just run weaker. It stops making heat.
Johnson County has also logged 9 winter storms and 179 damaging wind events over the past ten years. Storms like that knock out power, and a furnace needs power to run its blower and controls even on gas heat. When the power comes back, most furnaces restart on their own, but if yours does not, that is worth a call.
- 7 months
- October through April, your furnace is on duty
- 23°F
- the average winter night it heats against
- 69%
- of homes here heat with gas, so most furnaces here burn gas
- 9 winter storms
- in ten years, the nights a failure hurts most

NOAA nClimDiv, 1991–2020 normals
A new furnace would cut about $130 a year off heating for a typical Johnson County home.
Estimates for a typical Johnson County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Kansas fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed and the heat exchanger is sound.
Replacement makes sense when the heat exchanger is cracked or the furnace keeps needing parts.
In Kansas, HVAC licensing for homes is left to the counties and cities.
Furnace repair in Johnson County isn't covered by a state license, because Kansas leaves HVAC licensing to counties and cities. Whether a contractor is tested, registered, or neither depends on which local office covers the address. There's no state license number behind any of it, so the protection a homeowner gets here comes from whatever rule Johnson County itself has set, not from Topeka.
Most homes in Johnson County heat with gas, so a furnace repair usually means work on a gas line or a gas valve, the part of the job where a loose connection or a bad seal is dangerous. With no state license standing behind that work, what checks it here is whatever Johnson County's own rule requires of the contractor doing it.
Source: Kansas Office of Revisor of Statutes
- Why won't my furnace turn on?
- Most often the thermostat isn't calling for heat the way you think it is, or power isn't reaching the furnace. Check that the thermostat is set below room temperature and has working batteries if it uses them. Next check the furnace switch, the one that looks like a light switch near the unit, and the breaker at your panel. If those are fine, the igniter or flame sensor may have failed, and a contractor will need to test them.
- Why is my furnace blowing cold air?
- If air is running but it's cold, the furnace may be in fan-only mode. Check that the thermostat fan setting is on auto, not on. If it's already on auto and you're still getting cold air, the burners may not be lighting even though the blower is running, which points to an ignition problem a contractor needs to look at.
- Why won't my furnace pilot light stay lit?
- A pilot light that won't stay lit is usually a sign the thermocouple has worn out. That's the small sensor that sits in the pilot flame and tells the gas valve it's safe to keep sending gas. When it fails, the valve shuts the pilot off as a safety measure. A draft blowing out the flame is possible too, but if it keeps happening, the thermocouple needs to be replaced.


