Kansas HVAC Pros
A window view of a snow-covered yard with frost-laden evergreen trees and a brick house partially obscured by falling snow.

Furnace Repair in Paola, KS

Furnaces here run from October through April. If yours quits, tell us what it's doing and a licensed contractor who covers Miami County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
An unfinished basement containing a metal furnace with ductwork, exposed wooden joists on the ceiling, cardboard boxes, a coiled cable, and a single hanging incandescent bulb.

Seven months of work in the cold

Furnaces in Paola run from October through April. That is seven months of the year, with winter nights averaging 24°F from December through February. At that temperature, the burner is cycling on and off for hours at a stretch to keep the house warm, and every cycle puts wear on the igniter and the ignition control that fires it.

Miami County has seen 7 winter storms and 33 damaging wind events over the past ten years. Wind and ice take down power lines, and close to a fifth of Kansas households lost power for a day or more in 2024. Almost half the homes here heat with electricity, so when the power goes, the furnace stops with it, cold snap or not.

7 months
October through April, your furnace is on duty
24°F
the average winter night it heats against
7 winter storms
in ten years, the nights a failure hurts most
Isometric cutaway illustration of a single-story house with a dark shingled roof, showing interior rooms with furniture and a furnace connected to ductwork.
Your furnace works hardest from November through March.

NOAA nClimDiv, 1991–2020 normals

In Kansas, HVAC licensing for homes is left to the counties and cities.

Kansas leaves this to local government, so there is no state record of who is licensed to work on your furnace. Miami County or the city the house sits in may set its own rule, or set none at all, and that answer changes depending on which side of a line the address falls on. There is no statewide test, no state board, and no state license number to check either way.

For a furnace repair, the part that matters most is the gas connection, since that is where a mistake turns dangerous. Whether anyone checks that connection here depends on what Miami County or the city requires, and the state has no rule that fills that gap.

Source: Kansas Office of Revisor of Statutes

Why won't my furnace turn on?
Most often the thermostat isn't calling for heat the way it should, or power isn't reaching the furnace. Check that the thermostat is set below room temperature and has fresh batteries if it uses them. Next check the furnace switch, which looks like a light switch near the unit, and the breaker at your panel. If those are fine, the igniter or a safety switch inside the furnace may have failed, and that's a job for a contractor to diagnose.
Why is my furnace blowing cold air?
Check the thermostat fan setting first. If it's set to "on" instead of "auto", the blower runs even when the furnace isn't heating, which feels like cold air. If the setting is right and you're still getting cold air, the furnace may be failing to ignite, or the flame is going out partway through the cycle. A furnace that short-cycles like that shouldn't be run for long. Have a contractor look at the ignition system and the flame sensor.
Why won't my furnace pilot light stay lit?
A pilot light that won't stay lit usually means the thermocouple has worn out. That's the small sensor that sits in the pilot flame and tells the gas valve it's safe to keep the gas flowing. When it fails, the valve shuts the gas off as a safety measure, even though the pilot lit fine to start. A draft blowing across the pilot or a dirty pilot orifice can cause the same problem. A contractor can test the thermocouple and replace it if that's the cause.