Kansas HVAC Pros
Macro photograph of ice crystal formations creating feathery, fern-like patterns on a frost-covered window, with blurred bare trees visible through the glass.

HVAC Repair in Paola, KS

Homes here need heat from October through April and cooling from May through September. If your system quits, tell us what it's doing and a licensed contractor who covers Miami County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
A gray forced-air furnace with sheet-metal ductwork stands in an unfinished basement with exposed wooden joists, concrete walls, and a hanging incandescent bulb.

Twelve months of work, seven of them in the cold

Your furnace carries the load from October through April, and on the nights that average 24°F it cycles on and off for hours to keep up. Every start puts wear on the igniter and the flame sensor, and those parts are usually the first to fail once the cold sets in deep. Almost half the homes here heat with electricity, so a breaker problem or a bad heat strip can leave the house cold fast.

Come May the job flips to your air conditioner, and it runs hard through afternoons near 87°F straight through September. Kansas has seen its share of winter storms and damaging wind over the past ten years, the kind of weather that can knock out power for a stretch. Most systems come back on their own once power returns, but with 19% of Kansas households losing power for a full day or more in 2024, it is worth checking that yours did.

7 months
October through April, your system heats
5 months
May through September, it cools
24°F
the average winter night it heats against
87°F
the average summer afternoon it cools against
Isometric cutaway illustration of a small gabled house showing a furnace with flue pipe and ductwork connecting to interior rooms containing a sofa, bed, and cabinets.
Your system heats October through April and cools May through September.

NOAA nClimDiv, 1991–2020 normals

In Kansas, HVAC licensing for homes is left to the counties and cities.

Miami County sets its own rule, not the state, so whether a contractor needs a local license here depends on whether the county or a city inside it has set that requirement. Kansas keeps no state record of HVAC contractors at all. Where a local license exists, it is the only proof anyone checked this contractor's qualifications, and it holds only inside that city or county line.

For a repair on a heating and cooling system, that means the protection you get depends entirely on where the house sits. If Miami County or a city within it requires a license, that license is what stands behind the work. If it does not, there is no license standing behind it at all, and nothing at the state level fills that gap, since Kansas sets no rule of its own.

Source: Kansas Office of Revisor of Statutes

Why is my heat not working?
Most of the time it comes down to power, gas, or airflow. Check that the thermostat is set to heat and the temperature is above room temperature, then check the breaker and any furnace switch that looks like a light switch, usually near the unit. If you have a gas furnace, the pilot or igniter can fail, and a dirty flame sensor will shut the burners off soon after they light. A dirty filter can also starve the system of airflow until it locks out on high limit. With lows near 24°F overnight here, a furnace that will not stay lit needs a contractor before the house gets cold.
Why is my system running but not cooling the house?
If the blower is moving air but the air is not cold, the most common causes are a dirty filter, a frozen evaporator coil, or low refrigerant from a leak. A clogged filter cuts off airflow across the coil and the coil ices up, so warm room air passes over ice instead of cold refrigerant. Outside, the condenser unit needs clear airflow too, so leaves or grass clippings packed against it will cut cooling the same way. If the filter is clean and the outdoor unit is clear and you are still getting warm air, the system likely needs refrigerant or a repair a contractor has to diagnose.
What can I check before calling for HVAC repair?
Check the thermostat first. Make sure it is set to heat or cool as needed, the batteries are good, and the temperature setting is actually past room temperature. Next check the filter and replace it if it looks gray or clogged, since restricted airflow causes both heating and cooling complaints. Check the breaker box and any power switch near the indoor and outdoor units, since a tripped breaker or a flipped switch looks like a dead system but takes seconds to fix. If the outdoor unit is covered in leaves or debris, clear the area around it. If none of that solves it, a contractor will need to look at the system directly.