Kansas HVAC Pros
A snow-laden tree branch with dripping icicles hangs in the foreground during a winter storm, with a snow-covered residential house visible in the background.

Furnace Installation in Paola, KS

A new furnace here will run from October through April every year. Tell us about the house, and a licensed contractor who covers Miami County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
A gray forced-air furnace with metal ductwork stands in an unfinished basement with exposed wooden joists, concrete walls, and a single hanging light bulb.

What a Paola winter asks of a new furnace

Paola homes need heat from October through April, seven months of the year. Winter nights average 24°F, so a new furnace has to carry the house through most of the year, not just a few cold spells.

Almost half of homes here heat with electricity, and Kansas has seen its share of winter storms and wind events that knock out power. If a furnace depends on electricity to run, a power outage can leave a house without heat until it comes back. Any gas furnace installed today has to meet a federal minimum of 80 percent AFUE, so it's worth knowing where the model you're getting stands against that baseline.

7 months
October through April, your furnace is on duty
24°F
the average winter night it heats against
80% AFUE
the federal minimum any new unit must meet
Isometric cutaway illustration of a single-story house showing interior rooms with furniture, ceiling ductwork, and a large furnace unit with a tall flue pipe in a corner room.
Your furnace works hardest from November through March.

NOAA nClimDiv, 1991–2020 normals

In Kansas, HVAC licensing for homes is left to the counties and cities.

Miami County sets its own rule on who can do HVAC work, since Kansas leaves that to the counties and cities. That means whether a contractor needs a local license, and what it takes to get one, depends on the county or city office where the house sits, not on any state board or exam. There is no state record to check either way.

For a furnace installation, the protection that does exist here comes from the permit process. Most cities and counties require a permit before the old furnace comes out and an inspection once the new one is in, checking the gas connection, the venting, and the wiring against code. That inspection is what catches a bad gas line or an unsafe vent, the parts of this job that can hurt someone if they are done wrong.

Source: Kansas Office of Revisor of Statutes

What size furnace does my house need?
The right size depends on your square footage, how well the house is insulated, your ceiling height, and how many windows you have facing the cold. A furnace that's too big will short cycle and wear out faster. One that's too small will run constantly and still leave rooms cold when it's 24 degrees outside. A contractor will run a load calculation on your actual house rather than guess from square footage alone, and that's the number worth trusting.
How do I know it's time to replace my furnace?
Watch for uneven heat between rooms, a furnace that cycles on and off more than it used to, or a rise in your heating bills without a reason. Age matters too, and repairs get more frequent and less worth paying for as a furnace gets older. If yours is old and something major fails, like the heat exchanger, replacing it usually makes more sense than fixing it. A cracked heat exchanger or a furnace that trips its limit switch repeatedly is not something to leave alone with 7 months of heating season ahead.
Is a high-efficiency furnace worth it?
It depends on how long you plan to stay in the house and what you're paying now to heat it. Every furnace made since November 2015 has to hit at least 80 percent AFUE, so even a standard furnace today isn't inefficient. High-efficiency models go higher than that, and the gap matters more the longer your heating season runs. With homes here needing heat from October through April, those extra points of efficiency get more months to work. A contractor can walk through the actual cost difference for the unit you're considering.