Furnace Installation in Lawrence, KS
A new furnace here will run from October through April every year. Tell us about the house, and a licensed contractor who covers Douglas County will get in touch.
Tell us about the job
It takes about a minute.
Seven months of heat, and nights near 23 degrees
Lawrence homes need a working furnace from October through April, seven months out of the year. On winter nights the temperature averages 23°F, and a furnace here runs through that stretch without much rest.
Most homes in Douglas County heat with gas. Any non-weatherized gas furnace built after November 2015 has to reach at least 80 percent AFUE by federal rule, and that is the floor, not a target to aim for. Over the past ten years the county has seen 11 winter storms and 140 damaging wind events, and in 2024, 19% of Kansas households went at least 24 hours without power. A new furnace has to hold up through those conditions, not just an average night.
- 7 months
- October through April, your furnace is on duty
- 23°F
- the average winter night it heats against
- 59%
- of homes here heat with gas, so most furnaces here burn gas
- 80% AFUE
- the federal minimum any new unit must meet

NOAA nClimDiv, 1991–2020 normals
A high-efficiency gas furnace would save about $110 a year to run in Douglas County compared with a gas furnace.
Estimates for a typical Douglas County home, from EIA household energy data, Kansas fuel prices and NOAA climate normals. Your home will differ.
In Kansas, HVAC licensing for homes is left to the counties and cities.
Douglas County sets its own rule instead of relying on a state license, so whether a contractor needs to be licensed here depends on the county or city office that covers the address, not on a Topeka requirement. Where a license exists, it means the state tested and recorded the contractor. Here, that record does not exist at the state level, so anything protecting this job comes from county or city rules, not a license number you can check statewide.
For a furnace installation, the piece that stands in for that missing license is the permit. Replacing a furnace typically needs a permit from the local building office, and the work gets inspected once it is done. That inspection is what catches a bad gas connection, the part of this job that matters most, since gas furnaces run a fuel line that has to be sealed and vented correctly. With 59.3% of homes in Douglas County heating with gas, that inspection is doing real work here, not just paperwork.
Source: Kansas Office of Revisor of Statutes
- What size furnace does my house need?
- It depends on your house, not a rule of thumb. The right size comes from a load calculation that looks at your square footage, insulation, window count, and ceiling height, since two houses the same size can need different furnaces. A furnace that's too big will short cycle, turning on and off fast without heating evenly. One that's too small will run constantly and still struggle on the coldest nights, and with winter lows here averaging 23°F, undersized is the mistake you'll notice fast. A contractor can run this calculation for your house and tell you the right size before you buy anything.
- How do I know it's time to replace my furnace?
- Watch for rooms that won't heat evenly, a furnace that cycles on and off more than it used to, or a gas or burning smell that wasn't there before. An older furnace working harder to keep up is more likely to fail on the night you need it most. Since homes here need heat from October through April, a furnace already showing problems in fall is worth having checked before winter, not after it quits. A contractor can tell you whether what you're seeing means repair or replacement.
- Is a high-efficiency furnace worth it?
- Any furnace installed new today has to meet 80.0 percent AFUE at minimum, so even a standard model wastes less fuel than an older one. A high-efficiency furnace goes higher still, which matters more in a place where the furnace runs seven months of the year. The tradeoff is usually upfront cost against lower fuel use over the life of the unit, and that math depends on your home and your gas rate. A contractor can walk through the options for your house and price each one.


