Furnace Repair in Lawrence, KS
Furnaces here run from October through April. If yours quits, tell us what it's doing and a licensed contractor who covers Douglas County will get in touch.
Tell us about the job
It takes about a minute.
Seven months of heat wears a furnace down in Lawrence
Your furnace runs from October through April here, seven months of the year. On winter nights that average 23°F, it cycles on and off for hours at a stretch to hold the house steady, and each start puts a load on the igniter. Over enough winters that is often the part that fails.
Most homes here heat with gas, and a gas furnace needs power to run even though the flame does not. Kansas saw 19% of households lose power for a day or more in 2024. Most furnaces restart on their own once power comes back. If yours does not fire back up after an outage, or it is running constantly and the house still will not warm, that is worth a look before the next cold snap.
- 7 months
- October through April, your furnace is on duty
- 23°F
- the average winter night it heats against
- 59%
- of homes here heat with gas, so most furnaces here burn gas
- 11 winter storms
- in ten years, the nights a failure hurts most

NOAA nClimDiv, 1991–2020 normals
A new furnace would cut about $130 a year off heating for a typical Douglas County home.
Estimates for a typical Douglas County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Kansas fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed and the heat exchanger is sound.
Replacement makes sense when the heat exchanger is cracked or the furnace keeps needing parts.
In Kansas, HVAC licensing for homes is left to the counties and cities.
Whether the person working on your furnace needs a license depends on the address. Kansas has no state HVAC license, so it is up to Douglas County and the cities inside it to decide, and they do not all decide the same way. Where a city or county licenses HVAC contractors, someone tested them and there is a record of that. Where there is no such rule, there is no record at all, state or local.
For a furnace repair, the gas connection is the part that matters most, since a bad one is what makes the job dangerous. Kansas has no state inspector for that. Whether anyone checks it here comes down to whatever rule Douglas County or the city has set, not a statewide one. Gas heat is what most of Douglas County relies on, with 59.3% of homes heating that way, which is what makes that local rule the thing worth knowing.
Source: Kansas Office of Revisor of Statutes
- Why won't my furnace turn on?
- Start with the thermostat. If it's set to heat and above room temperature but nothing happens, check the power switch on the furnace itself, which looks like a light switch near the unit, and the breaker it runs on. Many furnaces also have a door that has to be seated correctly against a safety switch, so if it was left off or not closed all the way after a filter change, the furnace won't fire. If power and the door aren't the problem, something inside like the igniter or the flame sensor may have failed, and that calls for a contractor to check.
- Why is my furnace blowing cold air?
- In most cases the furnace hasn't warmed up yet. When it first starts, the blower can run for a short time before the air coming out of the vents feels warm, so cold air for the first minute or so is normal. If the air stays cold the whole time it runs, the igniter or gas valve may not be lighting the burners, and the blower is moving air that was never heated. That's a problem for a contractor to diagnose, since it usually means the furnace is drawing power and running the fan but not actually producing heat.
- Why won't my furnace pilot light stay lit?
- This usually means the thermocouple isn't sensing the flame and is shutting the gas off as a safety measure. The thermocouple is a small metal rod that sits in the pilot flame, and once it wears out or gets coated with soot, it can't tell the gas valve the flame is still burning. A draft blowing out the pilot is another common cause, especially where the flue or nearby vents let outside air in. Either way, this is a gas component, so it's worth having a contractor look at it rather than repeatedly relighting it.


