Furnace Repair in Topeka, KS
Furnaces here run from October through April. If yours quits, tell us what it's doing and a licensed contractor who covers Shawnee County will get in touch.
Tell us about the job
It takes about a minute.
Seven months of heat puts real wear on a furnace
Topeka homes need heat from October through April. That's seven months a year of the burner lighting and shutting off, day after day, and each cycle wears a little more on the igniter and the parts that get the burner going. On nights that average 22°F, the furnace is working hardest when you need it most.
Most homes here run on gas, so when the igniter or the flame sensor finally gives out, the burner won't light at all. Shawnee County also sees its share of winter storms and hard wind, and with them the power can go out. Gas furnaces need electricity to run the blower and controls, so no power means no heat even if the burner itself is fine.
- 7 months
- October through April, your furnace is on duty
- 22°F
- the average winter night it heats against
- 68%
- of homes here heat with gas, so most furnaces here burn gas
- 12 winter storms
- in ten years, the nights a failure hurts most

NOAA nClimDiv, 1991–2020 normals
A new furnace would cut about $130 a year off heating for a typical Shawnee County home.
Estimates for a typical Shawnee County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Kansas fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed and the heat exchanger is sound.
Replacement makes sense when the heat exchanger is cracked or the furnace keeps needing parts.
In Kansas, HVAC licensing for homes is left to the counties and cities.
Kansas leaves HVAC licensing to the counties and cities, so whether a contractor needs a local license here depends on Shawnee County and on the city the house sits in. There is no state exam behind the work and no state record of who passed one. Whatever rule applies comes from the county or the city, not from the state.
In Shawnee County, 68% of homes heat with gas, so a furnace repair here is usually a repair on a gas connection. A bad connection there is what makes the job worth doing right, and no state license here stands behind the work to catch it.
Source: Kansas Office of Revisor of Statutes
- Why won't my furnace turn on?
- Start with the thermostat. Check that it's set to heat and the setting is above room temperature, and put in fresh batteries if it takes them. If that's fine, check your breaker panel, since a tripped breaker will shut the furnace down with no warning. Furnaces also have a safety switch on the door panel, so make sure the panel is seated and latched all the way. If none of that gets it running, the igniter or a safety sensor may have failed, and that calls for a contractor to check.
- Why is my furnace blowing cold air?
- Most often this means the blower is running but the burners aren't lighting. A dirty flame sensor is a common cause, since it can't detect the flame and shuts the gas back off as a safety measure. A clogged filter can also starve the burners of airflow and trigger the same shutdown. If you've changed the filter recently and it's still blowing cold, the igniter or gas valve likely needs a contractor to look at it.
- Why won't my furnace pilot light stay lit?
- This usually points to the thermocouple, the small part that senses the pilot flame and keeps gas flowing to it. When it wears out or sits out of position, it reads the flame as out and cuts the gas, even with the pilot lit right in front of it. A draft blowing out the pilot is possible too, so check for anything blocking the vent nearby. If relighting it doesn't hold, the thermocouple needs replacing, and that's a job for a licensed contractor.


