Furnace Repair in Wamego, KS
Furnaces here run from October through April. If yours quits, tell us what it's doing and a licensed contractor who covers Pottawatomie County will get in touch.
Tell us about the job
It takes about a minute.
Seven months of cycling wears on the parts that light it
From October through April your furnace is what keeps the house warm, seven months a year, through nights that average 20°F. That is seven months of the burner lighting and shutting off over and over, and each start puts a little more wear on the igniter and the flame sensor. When one of those finally gives out, the furnace either won't light at all or it lights and then shuts back down soon after.
Storms add another way to lose heat. Pottawatomie County has seen 13 winter storms and 68 damaging wind events over the past ten years, and statewide, 19% of households went at least 24 hours without power in 2024. A furnace with no power will not run, but most gas furnaces come back on by themselves once the power does.
- 7 months
- October through April, your furnace is on duty
- 20°F
- the average winter night it heats against
- 53%
- of homes here heat with gas, so most furnaces here burn gas
- 13 winter storms
- in ten years, the nights a failure hurts most

NOAA nClimDiv, 1991–2020 normals
A new furnace would cut about $140 a year off heating for a typical Pottawatomie County home.
Estimates for a typical Pottawatomie County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Kansas fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed and the heat exchanger is sound.
Replacement makes sense when the heat exchanger is cracked or the furnace keeps needing parts.
In Kansas, HVAC licensing for homes is left to the counties and cities.
Kansas leaves the question to local government, so whether a furnace repair contractor needs a license depends on whether Pottawatomie County or the city the house sits in has set up its own system. Some counties and cities run a licensing program with testing behind it. Others have nothing on the books at all. There is no statewide list or state record either way, because the state itself does not license this trade.
A furnace burns gas, and the connection to the gas line is the part of the job where a mistake matters most. Whether that connection gets checked by anyone depends on what the local jurisdiction requires, not on a state license, since Kansas has none to point to. In Pottawatomie County, 52.8 percent of homes heat with gas, so that connection is part of the job in more than half the houses here.
Source: Kansas Office of Revisor of Statutes
- Why won't my furnace turn on?
- Most often the thermostat isn't calling for heat the way it should, or power isn't reaching the furnace. Check that the thermostat is set below room temperature and has working batteries if it uses them. Next check the furnace switch, which looks like a regular light switch near the unit, and the breaker at your electrical panel. If those are fine, the igniter or a safety switch inside the furnace may be the problem, and that calls for a contractor to look at it.
- Why is my furnace blowing cold air?
- A furnace usually blows cold air for a few seconds when it first starts, before the heat exchanger warms up. If cold air keeps coming the whole time it runs, the igniter may be failing to light the burners, or the flame sensor is shutting the burners off right after they start. A dirty filter can also cause this by restricting airflow enough to trip a safety limit. With nights averaging 20°F here in the winter, a furnace stuck blowing cold air needs attention quickly, and a contractor can find which part is at fault.
- Why won't my furnace pilot light stay lit?
- This usually means the thermocouple has worn out and is no longer sensing the pilot flame correctly, so it shuts off the gas as a safety measure. It can also happen if the pilot orifice is dirty or there's a draft reaching the pilot from a nearby vent. Furnaces with a standing pilot are older models, and parts like the thermocouple wear out over years of use. A contractor can test the thermocouple and replace it if that's the cause.


