Furnace Repair in Manhattan, KS
Furnaces here run from October through April. If yours quits, tell us what it's doing and a licensed contractor who covers Riley County will get in touch.
Tell us about the job
It takes about a minute.
Seven months of hard use, on nights near 21 degrees
Manhattan needs heat from October through April, seven months of the burner cycling on and off. On winter nights that average 21°F, it runs long and often to keep up. Every cycle asks the igniter to light the burner again, and that part wears a little more each time until one night it doesn't light at all.
Wind is part of the strain too. Riley County has seen 88 damaging wind events over the past ten years, and wind that strong can push against the flue or trip the pressure switch that keeps the furnace from running. Add in the 14 winter storms over that same stretch, and the power outages that come with them. Most furnaces restart on their own when the power comes back, but one that was already struggling may not.
- 7 months
- October through April, your furnace is on duty
- 21°F
- the average winter night it heats against
- 50%
- of homes here heat with gas, so most furnaces here burn gas
- 14 winter storms
- in ten years, the nights a failure hurts most

NOAA nClimDiv, 1991–2020 normals
A new furnace would cut about $140 a year off heating for a typical Riley County home.
Estimates for a typical Riley County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Kansas fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed and the heat exchanger is sound.
Replacement makes sense when the heat exchanger is cracked or the furnace keeps needing parts.
In Kansas, HVAC licensing for homes is left to the counties and cities.
Kansas leaves this to Riley County and the cities inside it, so there is no state license to check either way. Some counties and cities test and license furnace contractors before they can work, others just register the business, and some have no rule at all. Which one applies here depends on the address, not on anything the state sets.
What that means for a gas furnace repair is that whatever check exists comes from the county or city, not a state license. A gas connection that is not sealed or vented right is the dangerous part of this job. Whether anyone here inspects that connection depends on Riley County's own rule, since the state does not set one. Just over half the homes in Riley County heat with gas.
Source: Kansas Office of Revisor of Statutes
- Why won't my furnace turn on?
- Most often the thermostat isn't calling for heat the way it should, or power isn't reaching the furnace. Check that the thermostat is set below room temperature and has fresh batteries if it uses them. Next check the furnace switch, which looks like a light switch near the unit, and the breaker for it. If those are fine, the igniter or a safety switch inside the furnace may have failed, and that's a job for a contractor to diagnose.
- Why is my furnace blowing cold air?
- Check the thermostat fan setting first. If it's set to "on" instead of "auto", the blower runs all the time, including between heating cycles when the air isn't warm. If it's already set to auto and you're still getting cold air, the furnace may be failing to ignite the gas even though the blower kicks on, which points to the igniter or a dirty flame sensor. A furnace that short-cycles or won't stay lit needs a contractor to look at the burner assembly.
- Why won't my furnace pilot light stay lit?
- A pilot light that won't stay lit usually means the thermocouple has worn out or there's a draft or dirt at the pilot itself. The thermocouple is the small sensor that tells the gas valve the pilot is burning, and once it fails, the valve shuts the gas off as a safety measure. Cleaning around the pilot can help if debris is the cause, but a thermocouple has to be replaced, not repaired. Newer furnaces mostly use electronic ignition instead of a standing pilot, so this points to an older unit.


