Furnace Installation in Manhattan, KS
A new furnace here will run from October through April every year. Tell us about the house, and a licensed contractor who covers Riley County will get in touch.
Tell us about the job
It takes about a minute.
Manhattan asks a lot of a furnace
Winter nights here average 21°F, and homes need heat from October through April, seven months of the year. That is most of the year spent leaning on a furnace to keep a house livable.
About half of homes in the area heat with gas, and any new gas furnace has to reach at least 80 percent AFUE under federal rules. Riley County has also logged 14 winter storms and 88 damaging wind events over the last ten years, the kind of weather that knocks out power along with the heat. Statewide, 19 percent of households went at least 24 hours without power in 2024, so a furnace here needs to start back up on its own once the power does.
- 7 months
- October through April, your furnace is on duty
- 21°F
- the average winter night it heats against
- 50%
- of homes here heat with gas, so most furnaces here burn gas
- 80% AFUE
- the federal minimum any new unit must meet

NOAA nClimDiv, 1991–2020 normals
A high-efficiency gas furnace would save about $120 a year to run in Riley County compared with a gas furnace.
Estimates for a typical Riley County home, from EIA household energy data, Kansas fuel prices and NOAA climate normals. Your home will differ.
In Kansas, HVAC licensing for homes is left to the counties and cities.
Kansas leaves HVAC licensing to the counties and cities, so what's on file for a contractor working in Riley County depends on local rules rather than a state credential. There's no state board testing or recording HVAC contractors here.
For a furnace installation, the protection you actually have is the permit and inspection process. Riley County or the city building office typically requires a permit for a furnace replacement, and an inspection once the work is done checks that the gas connection and venting were done right. That inspection is what stands between you and bad work here, not a license number.
Source: Kansas Office of Revisor of Statutes
- What size furnace does my house need?
- The right size depends on your square footage, your insulation, your windows, and your home's layout, so there's no number that works for every house. A contractor works this out with a load calculation, not a chart based on square footage alone. A furnace that's too big will short cycle and wear out faster. One that's too small will run constantly and still leave rooms cold on the coldest nights, and here that means nights near 21°F. Get the calculation done rather than guessing from the size of your old unit.
- How do I know it's time to replace my furnace?
- Age is the first thing to check. If your furnace has been running a long time and needs a repair, that repair may just delay a replacement you'll need soon anyway. Watch for other signs too. Rooms that won't heat evenly, a furnace that cycles on and off more than it used to, or a repair bill that starts to rival what a new unit would cost. Homes here need heat from October through April, seven months of the year, so a furnace on its last legs doesn't get much of a break to fail quietly. If yours is old and struggling, have it looked at before the cold months, not during one.
- Is a high-efficiency furnace worth it?
- It depends on how much you heat and how long you plan to stay in the house. Every non-weatherized gas furnace built new today has to reach at least 80 percent AFUE, so even a standard furnace isn't inefficient anymore. A high-efficiency model burns less gas to produce the same heat, and that matters more in a place like this where furnaces run seven months a year with winter nights averaging 21°F. Over half the homes in this area heat with gas, so the fuel savings add up for a lot of people here. A contractor can walk you through the options and price out what fits your house.


