Water Heater Installation in Manhattan, KS
Tell us about the house, and a licensed contractor who covers Riley County will get in touch.
Tell us about the job
It takes about a minute.
Manhattan puts a new water heater to work all year
Winter nights here average 21°F from December through February, and the incoming water feeding the tank is just as cold. A water heater has to work harder to bring that water up to temperature than one in a milder climate, and it does that work through a long heating season, October through April.
Kansas households aren't strangers to losing power. Riley County has logged 14 winter storms and 88 damaging wind events over the past ten years, and statewide, 19% of households went at least a day without power in 2024. A gas water heater with a standing pilot keeps making hot water through an outage. One with electric ignition won't light until power is back, but most relight on their own once it returns.
The federal minimum efficiency for a new storage water heater depends on the size of the tank, not just the type. A larger tank and a smaller one of the same kind are held to different minimums, so the right efficiency level for a home here depends on how much hot water that home actually uses.
- 21°F
- the average winter night, and colder incoming water means longer heating
- 7 months
- October through April, the months homes here need heat
- 19%
- of Kansas households lost power for a day or more in 2024, and a heater with an electric element or electric ignition stops without it

NOAA nClimDiv, 1991–2020 normals
A heat pump water heater would save about $320 a year to run in Kansas compared with an electric water heater.
Estimates for a typical Kansas home, from EIA household energy data and Kansas fuel prices. Your home will differ.
- How do I know it's time to replace my water heater?
- Water pooling at the base of the tank means it's done, and that's the clearest sign there is. Rusty water coming from the hot tap, especially when the cold side runs clear, usually points to corrosion inside the tank itself rather than the pipes. A tank that's making rumbling or popping noises has sediment built up on the bottom, and once that starts the unit is working harder to heat the same water. If yours is old enough that you can't remember installing it, that's worth checking too. If it's showing any of these signs, replacing it before it fails is easier than dealing with a flooded closet or basement.
- Should I switch to a tankless water heater?
- It depends on what you want out of it, not on whether tankless is simply better. A tankless unit heats water as it flows through, so you don't run out of hot water during a long shower or back to back loads of laundry the way you can with a tank. It also takes up much less space, which matters if the water heater is in a closet or a tight utility area. What it won't do is deliver hot water instantly at the tap, since the water still has to travel through the pipes. Switching also usually means changes to the gas line, venting, or electrical, so a contractor will need to look at the space before pricing it out.
- What changes when you install a tankless water heater?
- The biggest change is what the unit needs to run, not just what it looks like on the wall. A gas tankless heater needs a larger gas line than most tank heaters use, because it has to heat water on demand rather than gradually over time. Venting is different too, usually requiring dedicated venting rated for the higher temperatures involved. If you're switching from a tank to tankless, the mounting location often changes as well, since tankless units go on a wall rather than sitting on the floor. Because of all this, installing tankless is more involved than swapping one tank for another, and a contractor will need to see the space to say what's required.


