Furnace Repair in Junction City, KS
Furnaces here run from October through April. If yours quits, tell us what it's doing and a licensed contractor who covers Geary County will get in touch.
Tell us about the job
It takes about a minute.
Seven months of Kansas cold wears a furnace down
From October through April your furnace is what stands between your house and a 21°F night. That is seven months of cycling on and off to hold the temperature, and every start puts a load on the igniter and the parts that get the burner lit. When an igniter finally gives out, the furnace won't fire at all.
Geary County has seen 11 winter storms and 92 damaging wind events over the past ten years. Wind like that pulls heat out of a house fast and pushes a furnace to run longer and more often to keep up. Power is part of the picture too. In Kansas, 19% of households went at least 24 hours without power in 2024, and a furnace with electronic ignition won't restart on its own once the power is back.
- 7 months
- October through April, your furnace is on duty
- 21°F
- the average winter night it heats against
- 50%
- of homes here heat with gas, so most furnaces here burn gas
- 11 winter storms
- in ten years, the nights a failure hurts most

NOAA nClimDiv, 1991–2020 normals
A new furnace would cut about $130 a year off heating for a typical Geary County home.
Estimates for a typical Geary County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Kansas fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed and the heat exchanger is sound.
Replacement makes sense when the heat exchanger is cracked or the furnace keeps needing parts.
In Kansas, HVAC licensing for homes is left to the counties and cities.
Geary County sets its own rule for who can do this kind of work, and whether a contractor needs a local license here depends on the county or city office that covers the address, not on anything the state tracks. Kansas keeps no state list of HVAC contractors, so there is no state exam behind the name on the truck. Whatever check exists on a furnace repair here comes from Geary County itself.
A furnace repair means someone is working around a gas line, and the dangerous part of that job is a bad connection. In a county that licenses contractors, that license is what stands behind the work. Just over half the homes in Geary County heat with gas, which is why that connection is the part of the job that matters most here.
Source: Kansas Office of Revisor of Statutes
- Why won't my furnace turn on?
- Most often the thermostat isn't calling for heat, or the furnace isn't getting power or gas. Check that the thermostat is set above room temperature and has fresh batteries if it uses them. Check the furnace switch, which looks like a light switch near the unit, and the breaker at your panel. If those are fine, the igniter or a safety switch may be the problem, and that calls for a contractor to check it out. With winter lows here averaging 21°F, it's worth getting this looked at quickly.
- Why is my furnace blowing cold air?
- If air is running but not warm, the furnace may be stuck in fan-only mode, so check that the thermostat is set to heat and not just fan. A dirty filter can also make the furnace shut its burners off while the blower keeps running, so check the filter next. If the air was warm and turned cold partway through a cycle, the igniter or flame sensor is likely failing and a contractor will need to test it.
- Why won't my furnace pilot light stay lit?
- A pilot that won't stay lit usually means the thermocouple has worn out and no longer senses the flame correctly, so the gas valve shuts it off as a safety measure. It can also mean a draft is blowing the flame out, or the pilot orifice is partly clogged. Relighting it yourself may work for a night, but if it keeps going out, the thermocouple needs to be replaced by a contractor. Furnaces with a standing pilot don't need power to keep the pilot lit, so a power outage isn't the cause.


