Kansas HVAC Pros
A snow-covered suburban house at dusk with one illuminated window and a double garage door.

HVAC Installation in Junction City, KS

A new system here will heat from October through April and cool from May through September every year. Tell us about the house, and a licensed contractor who covers Geary County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
An unfinished basement featuring a grey forced-air furnace with metal ductwork, concrete block walls, exposed wooden joists, and a single hanging bare bulb.

A new system here has to handle both ends of the year

Winter nights in Junction City average 21°F from December through February, and a new furnace needs to keep up with that for seven months, October through April. Summer swings the other way, with afternoons averaging 88°F and the air conditioner running May through September. That leaves almost no time of year when the system gets a break.

Half the homes here heat with gas, so the furnace is doing real work on those cold nights, not just topping off the house. And with 19% of Kansas households losing power for at least a day in 2024, and eleven winter storms and 92 damaging wind events recorded here over the past ten years, a new installation is worth planning with outages in mind, not just the temperature swings.

7 months
October through April, your system heats
5 months
May through September, it cools
21°F
the average winter night it heats against
88°F
the average summer afternoon it cools against
Isometric cutaway illustration of a single-story house showing interior rooms, a furnace unit with connected ductwork, and a flue pipe extending through the dark shingled roof.
Your system heats October through April and cools May through September.

NOAA nClimDiv, 1991–2020 normals

In Kansas, HVAC licensing for homes is left to the counties and cities.

Geary County does not run its own contractor license either, so nothing here has been tested or recorded by any government office. Whatever standard exists comes from whichever local building office covers the address, if it has one at all.

For this installation, the permit is what stands in for that missing record. In most cities and counties, replacing a furnace, air conditioner or heat pump needs a permit from the local building office, and the finished work gets inspected. That inspection is what checks the gas connections, wiring and refrigerant lines were done right, since a bad gas connection is the dangerous part of this job.

Source: Kansas Office of Revisor of Statutes

When should I replace my HVAC system?
Replace it when repairs stop making sense or the system can't keep up anymore. A system that needs repairs more often than not is usually a better candidate for replacement than another fix. Watch for signs like rooms that won't hold temperature, a system that runs constantly, or a jump in energy bills with no other explanation. Here winters drop to 21°F on average and summers climb to 88°F, so a system that's struggling has to work harder for longer, which tends to speed up the decline.
Should I replace my furnace and air conditioner at the same time?
If they're close in age, yes, it usually makes sense to replace both together. A furnace and air conditioner installed at the same time wear down on a similar schedule, so if one is failing the other is probably not far behind. Matching the two also means the system is built to work as one unit rather than pairing new equipment with an aging coil or blower. Homes here need heat October through April and cooling May through September, so the system runs nearly all year with barely a break, which is another reason not to let one half lag behind the other.
What happens during an HVAC installation?
A contractor removes the old equipment, sets the new furnace, air conditioner or heat pump, and connects it to the ductwork, gas or electric lines, and refrigerant lines as needed. They'll check that the ducts are sized right for the new equipment and test the system once it's running to confirm it's heating and cooling correctly. Most cities and counties require a permit for this kind of replacement, along with an inspection once the work is finished. A contractor pricing the job will walk through the specifics for your house before any of this starts.