HVAC Installation in Wamego, KS
A new system here will heat from October through April and cool from June through September every year. Tell us about the house, and a licensed contractor who covers Pottawatomie County will get in touch.
Tell us about the job
It takes about a minute.
Wamego asks for heat and cooling most of the year
Heat runs October through April here, seven months, and on winter nights averaging 20°F a new furnace has to keep up for hours at a stretch, not just take the chill off. Cooling runs June through September, four months, with summer afternoons averaging 87°F pushing the outdoor unit hard all season. Together that is 11 months where a home here needs one system or the other working.
More than half the homes in the area heat with gas, so a new furnace has to be sized for those 20°F nights, not just the mild ones. The area has logged 13 winter storms and 68 damaging wind events over the past ten years, and statewide, close to a fifth of households lost power for at least 24 hours in 2024. A new system going in here should be able to hold up through that kind of weather, not just an ordinary week.
- 7 months
- October through April, your system heats
- 4 months
- June through September, it cools
- 20°F
- the average winter night it heats against
- 87°F
- the average summer afternoon it cools against

NOAA nClimDiv, 1991–2020 normals
In Kansas, HVAC licensing for homes is left to the counties and cities.
Pottawatomie County sets its own rule for HVAC contractors, not the state. Kansas keeps no state license and no state record of who is qualified to do this work, so whatever record exists here comes from the county or the city the house sits in, not from Topeka.
For this installation, the protection comes from the permit process rather than a license. Most cities and counties in Kansas require a permit before a furnace or air conditioner goes in, and an inspection once the work is done. That inspection is what checks the gas connection and the wiring, the two parts of the job where a mistake turns dangerous.
Source: Kansas Office of Revisor of Statutes
- When should I replace my HVAC system?
- Replace it when repairs get frequent, the unit is old, or it can't keep up on the coldest or hottest days. A furnace working through 7 months of heating season here wears differently than one in a milder climate, so how it's been running tells you more than the date on the nameplate. If someone is coming out more than once a season, or a repair bill is climbing close to what a new system would run, that's the point to stop patching it. A contractor can look at the specific unit and tell you if it's worth another repair or not.
- Should I replace my furnace and air conditioner at the same time?
- If both are old, yes, it usually makes sense to do them together. A furnace and air conditioner installed at the same time are matched to work as one system, and pairing an old unit with a new one can mean the new one never runs at its full efficiency. Homes here need heat from October through April and cooling from June through September, so both halves of the system see real work most of the year. If only one has failed and the other is still young, a contractor can tell you whether it's worth replacing both now or waiting.
- What happens during an HVAC installation?
- A contractor removes the old furnace, air conditioner or heat pump and sets the new equipment in place, connecting it to the ductwork, gas or electric line, and condensate drain. They check that the ducts and electrical connections are sized right for the new unit, not just bolt it in where the old one sat. Most cities and counties here require a permit for this work and an inspection once it's done, so the installer should handle that as part of the job. Once everything is connected, they test the system to make sure it is heating or cooling properly before they leave.

