HVAC Repair in Wamego, KS
Homes here need heat from October through April and cooling from June through September. If your system quits, tell us what it's doing and a licensed contractor who covers Pottawatomie County will get in touch.
Tell us about the job
It takes about a minute.
Eleven months of work, most years
Your furnace runs October through April in Wamego, and your air conditioner takes over in June. That leaves only a month or so when the system gets a real rest. Winter nights averaging 20°F mean the burner cycles on and off for hours at a stretch, and each start puts wear on the igniter and the ignition control board. When one of those parts finally gives out, the furnace stops firing and the house goes cold overnight.
Summer afternoons near 87°F push the air conditioner just as hard from the other direction. The compressor runs long hours to keep up, and that steady load is what wears down a capacitor or a contactor over time. Wind is part of the picture too. Pottawatomie County has logged 68 damaging wind events over the past ten years, and wind-driven debris is hard on an outdoor condenser coil sitting exposed in the yard.
- 7 months
- October through April, your system heats
- 4 months
- June through September, it cools
- 20°F
- the average winter night it heats against
- 87°F
- the average summer afternoon it cools against

NOAA nClimDiv, 1991–2020 normals
A new furnace and air conditioner would cut about $170 a year off heating and cooling for a typical Pottawatomie County home.
Estimates for a typical Pottawatomie County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Kansas fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed.
Replacement makes sense when the furnace's heat exchanger is cracked, the air conditioner's compressor has failed, or repairs keep coming.
In Kansas, HVAC licensing for homes is left to the counties and cities.
Source: Kansas Office of Revisor of Statutes
- Why is my heat not working?
- The most common reason is that the igniter or the flame sensor has failed, so the furnace tries to start but shuts itself off. A clogged filter can also starve the system of airflow until it trips a safety switch and stops. Check your thermostat batteries and your breaker panel first, since those are quick things to rule out. At 20°F on a winter night here, it is worth calling for repair the same day rather than waiting.
- Why is my system running but not cooling the house?
- If the blower is running but the air is not cold, the system is likely low on refrigerant or the outdoor coil is dirty or frozen. A dirty filter can also cut off airflow enough that the coil ices up even though the compressor is working fine. Check the filter first, since that is something you can see and fix yourself. If the outdoor unit is caked with dirt or grass clippings, clearing the area around it can help too, but a refrigerant leak needs a licensed contractor to find and repair.
- What can I check before calling for HVAC repair?
- Start with the thermostat. Make sure it is set to heat or cool as needed and that the batteries are fresh. Next check the filter, since a clogged one can cause both heating and cooling problems, and check your breaker panel for a tripped switch. If the outdoor unit is covered in leaves or debris, clear it. If none of that fixes it, a contractor will need to look at the equipment itself.


