Kansas HVAC Pros
Close-up of elaborate ice crystal formations covering a window pane, with blurred evergreen trees visible through the frosted glass.

HVAC Repair in Topeka, KS

Homes here need heat from October through April and cooling from May through September. If your system quits, tell us what it's doing and a licensed contractor who covers Shawnee County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
An unfinished basement featuring concrete block walls, exposed floor joists, and a metal forced-air furnace with ductwork near a central pillar.

Shawnee County asks a lot of your system, year round

Your furnace carries the house from October through April, with winter nights averaging 22°F. On the coldest nights it runs almost constantly, cycling the igniter and blower over and over to keep up. That kind of use wears down the igniter first, and when it goes, the furnace won't light at all.

Come May, your air conditioner takes over for five months of afternoons averaging 88°F. The compressor is what strains hardest in that heat, and a system already worn from winter often shows it first in the cooling season, tripping off or blowing air that isn't cold. Add in the wind this area sees, 224 damaging wind events over the past ten years, and the outdoor unit itself takes a beating from debris and storm damage on top of the heat.

7 months
October through April, your system heats
5 months
May through September, it cools
22°F
the average winter night it heats against
88°F
the average summer afternoon it cools against
Isometric line illustration of a cutaway single-story house with a dark shingled roof, showing interior rooms and ductwork connected to a gray furnace unit with a flue pipe.
Your system heats October through April and cools May through September.

NOAA nClimDiv, 1991–2020 normals

A gray forced-air furnace with ductwork stands in an unfinished concrete basement surrounded by storage items and clutter.

A new furnace and air conditioner would cut about $160 a year off heating and cooling for a typical Shawnee County home.

  • A new furnace and AC$860 a year
  • An older furnace and AC$1,020 a year

Estimates for a typical Shawnee County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Kansas fuel prices and NOAA climate normals. Your home will differ.

Repair makes sense when one part has failed.

Replacement makes sense when the furnace's heat exchanger is cracked, the air conditioner's compressor has failed, or repairs keep coming.

In Kansas, HVAC licensing for homes is left to the counties and cities.

Source: Kansas Office of Revisor of Statutes

Why is my heat not working?
Most of the time it's the igniter, a flame sensor that needs cleaning, or the thermostat set wrong or dead on batteries. Check the thermostat first since it's the quickest thing to rule out. If the furnace is trying to start but won't stay lit, that's usually the flame sensor. With winter nights here averaging 22°F, a furnace that's stopped working needs a contractor out soon rather than waiting it out.
Why is my system running but not cooling the house?
Check the air filter first. A filter clogged with dust blocks airflow across the coil, and when that happens the coil can ice over so the system runs but barely cools. If the filter is clean and you still get warm air, the refrigerant charge is low or the outdoor unit's coil is dirty, and that needs a contractor's gauges to sort out. A thermostat set to "on" instead of "auto" will also run the blower nonstop without actually cooling much, so check that too.
What can I check before calling for HVAC repair?
Start with the thermostat. Make sure it's set to heat or cool as needed, the batteries are good, and the temperature setting actually calls for what you want. Next check the air filter, since a dirty one chokes airflow on both heating and cooling systems. Then look at your breaker panel for a tripped breaker, and if you have a gas furnace, make sure the gas valve is open. If all of that checks out and the system still isn't working right, a contractor will need to look at it directly.