HVAC Installation in Topeka, KS
A new system here will heat from October through April and cool from May through September every year. Tell us about the house, and a licensed contractor who covers Shawnee County will get in touch.
Tell us about the job
It takes about a minute.
What a system in Shawnee County has to handle
Your furnace and your AC both earn their keep here. Winter nights average 22°F from December through February, and summer afternoons run 88°F, so a new system needs to hold up on both ends. Heat runs October through April, seven months. Cooling covers May through September, five months. That leaves the system working nearly all year, with only short stretches when it can rest.
Most homes in the area heat with gas, and whatever you install has to meet the federal efficiency minimum that applies now. Storms are part of the picture too. Shawnee County has logged 12 winter storms and 224 damaging wind events over the past ten years, and in 2024 nearly one in five Kansas households lost power for a full day or more. A furnace that won't restart on its own after an outage, or a unit already worn down before a storm hits, is the kind of thing that turns a bad night into a bad week.
- 7 months
- October through April, your system heats
- 5 months
- May through September, it cools
- 22°F
- the average winter night it heats against
- 88°F
- the average summer afternoon it cools against

NOAA nClimDiv, 1991–2020 normals
In Kansas, HVAC licensing for homes is left to the counties and cities.
Whether this installer needs a local license depends on Shawnee County and the city where the house sits, since Kansas keeps no state list of licensed HVAC contractors and runs no test for them. If a license is required here, it comes from the county or city, not the state.
What covers this job either way is the permit. Installing a furnace or air conditioner in most cities and counties means the contractor pulls a permit from the local building office, and the finished work gets inspected before it's signed off. That inspection is what checks the work, including the gas connections on a furnace, not a license.
Source: Kansas Office of Revisor of Statutes
- When should I replace my HVAC system?
- Replace it when repairs start happening every year, or when a repair would cost close to a new system anyway. Watch for weaker airflow, rooms that never heat or cool right, and a furnace that short cycles or won't hold a flame. Here the furnace runs October through April and the air conditioner runs May through September, so a failure in either one means real discomfort fast, with winter lows averaging 22°F and summer afternoons averaging 88°F. If yours is struggling, get it looked at before the next heating or cooling season starts.
- Should I replace my furnace and air conditioner at the same time?
- If both are old and struggling, it often makes sense to do both at once. A furnace and air conditioner installed at different times were not always matched to work together well, and pairing the replacement means the contractor only has to open up the ductwork and wiring once. Homes here run the furnace 7 months a year and the air conditioner 5, so both units see heavy use and tend to wear out around the same time. A contractor can look at the age and condition of each and tell you whether replacing them together makes sense for your house.
- What happens during an HVAC installation?
- A contractor removes the old furnace, air conditioner or heat pump and sets the new equipment in place, then connects it to the ducts, gas line or refrigerant lines, and electrical. They test the system for correct airflow, refrigerant charge, and safe operation before calling the job done. In most cities and counties here, this work needs a permit from the local building office, and an inspector checks it once it is finished. Kansas leaves HVAC licensing to individual counties and cities, so it is worth confirming the contractor is licensed where your home is.

