Kansas HVAC Pros
A snow-dusted white window frame with a frost-covered sill, looking out onto a snow-covered backyard during a snowstorm.

HVAC Installation in Lawrence, KS

A new system here will heat from October through April and cool from May through September every year. Tell us about the house, and a licensed contractor who covers Douglas County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
An unfinished basement featuring concrete block walls, exposed floor joists, and a metal forced-air furnace with ductwork near a central pillar.

A system built for both ends of the year

In Lawrence, the furnace runs from October through April. On the coldest nights it is holding the house steady against a low around 23°F, and it does that seven months of the year. Come May, the air conditioner takes over, working against summer afternoons that average 87°F through September. There is no real off season here. Twelve months a year, one system or the other is running.

That kind of year-round load is why sizing and installation matter as much as the equipment itself. A furnace or air conditioner that is too big or too small for the house will run poorly no matter how good the brand is. Most homes in this area heat with gas, and any new system installed still has to meet the federal minimum efficiency standard. Wind is worth planning around too. Douglas County has seen 140 damaging wind events over the past ten years, and installation should account for what that means for outdoor equipment.

7 months
October through April, your system heats
5 months
May through September, it cools
23°F
the average winter night it heats against
87°F
the average summer afternoon it cools against
Isometric cutaway illustration of a small house showing a furnace unit connected to ductwork running through the interior and attic, with a chimney on the shingled roof and simple furniture in the rooms.
Your system heats October through April and cools May through September.

NOAA nClimDiv, 1991–2020 normals

In Kansas, HVAC licensing for homes is left to the counties and cities.

Douglas County sets its own rule for who can do this work, since Kansas leaves that decision to counties and cities. There is no state record of testing or credentials to check here. In most cities and counties, a job like this needs a permit from the local building office, with an inspection once the work is done.

For a heating and cooling installation, that permit and inspection are what confirms the job was done right, not a license number. The inspector checks the installation once it is in place. That matters most on the gas connection if the system includes a furnace, since a bad connection there is the dangerous part of the job.

Source: Kansas Office of Revisor of Statutes

When should I replace my HVAC system?
Once repairs start happening every year, or the system can't keep up on the coldest nights or hottest afternoons, it's time to replace it rather than fix it again. A furnace or air conditioner working harder than it should wears out its parts faster, and an old system straining through a 23°F night or an 87°F afternoon here is telling you something. Age matters too. If yours is old enough that parts are getting hard to find, that's another sign the next breakdown should be the last one.
Should I replace my furnace and air conditioner at the same time?
If both are old, replacing them together usually makes sense, even though it isn't required. A furnace and air conditioner installed at the same time are matched to work together, and a contractor sizing a new system can size it correctly for your house instead of building around whatever is already there. Homes here need heat seven months of the year and cooling five, so both sides of the system get real use and neither one is an afterthought.
What happens during an HVAC installation?
A contractor removes the old equipment, sets the new furnace, air conditioner or heat pump in place, and connects it to the ductwork, gas line or refrigerant lines and electrical it needs. Once it's running, they test it, check refrigerant charge and airflow, and walk through what was done. In most cities and counties here, this work needs a permit from the local building office and an inspection afterward, so the contractor handling your installation should be pulling that permit as part of the job.