HVAC Installation in Leavenworth, KS
A new system here will heat from October through April and cool from May through September every year. Tell us about the house, and a licensed contractor who covers Leavenworth County will get in touch.
Tell us about the job
It takes about a minute.
A new system here works almost year round
Leavenworth County asks for heat from October through April and cooling from May through September. That is 12 months a year of one or the other, with barely a break between. Winter nights average 23°F, cold enough that a furnace runs its burner many times a day for months straight. Summer afternoons average 87°F, so the system you install has to handle both ends without much rest in between.
Most homes here heat with gas, and whatever you install has to meet the federal minimum efficiency rating for this region. The county has also seen 92 damaging wind events and 7 winter storms over the past ten years, and close to a fifth of Kansas households lost power for a full day or more in 2024. A new furnace or air conditioner should be sized and installed to hold up through that kind of weather, not just the mild days in between.
- 7 months
- October through April, your system heats
- 5 months
- May through September, it cools
- 23°F
- the average winter night it heats against
- 87°F
- the average summer afternoon it cools against

NOAA nClimDiv, 1991–2020 normals
In Kansas, HVAC licensing for homes is left to the counties and cities.
Kansas leaves HVAC licensing to the counties and cities, so whether this contractor needs a local license depends on where the house sits in Leavenworth County. There is no state test or state record to check either way. What exists instead is whatever the local building office requires, and that varies by city and county.
For an install like this, in most cities and counties, replacing a furnace and air conditioner needs a permit from the local building office, and the finished work gets an inspection before it is signed off. That inspection is what checks the gas connections, wiring and refrigerant lines were done right, not a license number.
Source: Kansas Office of Revisor of Statutes
- When should I replace my HVAC system?
- Replace it when repairs keep coming back for the same problem, or when the system can't keep up on the coldest nights or hottest afternoons. Homes here need heat or cooling all 12 months of the year, so a unit that's struggling doesn't get much of a break to show it. If a contractor has already been out more than once this year for the same issue, that's usually a sign the system is done, not just having a bad week.
- Should I replace my furnace and air conditioner at the same time?
- If both are getting old, yes, it often makes sense to do it together. Homes here need heat from October through April and cooling from May through September, so both units run hard with barely a break between seasons, and when one is worn out the other usually isn't far behind. A furnace and air conditioner installed as a matched pair tend to work better together than a new unit paired with an old one. A contractor can look at both and tell you whether replacing just one now holds up or whether doing the job once makes more sense.
- What happens during an HVAC installation?
- A contractor sizes the new equipment to your house rather than just matching what's already there, since a unit that's too big or too small will short cycle or run constantly. The old furnace, air conditioner or heat pump comes out, and the new one goes in along with any duct, wiring or venting work it needs. Most cities and counties require a permit for this job and an inspection once it's finished, and the contractor should handle that as part of the work. Before they leave, the system gets run through a full cycle to confirm it's heating and cooling the way it should.

