Kansas HVAC Pros
A two-story suburban house blanketed in snow at night, with one lit upstairs window and bare trees surrounding it.

Furnace Installation in Overland Park, KS

A new furnace here will run from October through April every year. Tell us about the house, and a licensed contractor who covers Johnson County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
An unfinished basement featuring concrete block walls, exposed floor joists, and a metal forced-air furnace with ductwork near a central pillar.

Overland Park asks a lot of a furnace

Your furnace runs October through April here, seven months of the year. Winter nights average 23°F, so it is not a matter of a few cold snaps. It is a long stretch of steady work.

Most homes in the area heat with gas, and any new gas furnace installed today has to reach at least 80 percent AFUE. Winter storms are common here too, nine of them over the past ten years, along with 179 damaging wind events. When the power goes out, a furnace with a standing pilot will still light. One with electronic ignition will not until the power is back.

7 months
October through April, your furnace is on duty
23°F
the average winter night it heats against
69%
of homes here heat with gas, so most furnaces here burn gas
80% AFUE
the federal minimum any new unit must meet
Isometric illustration of a cutaway single-story house showing a gray furnace unit, connected ductwork, and a vertical flue extending above the dark shingled roof.
Your furnace works hardest from November through March.

NOAA nClimDiv, 1991–2020 normals

An unfinished basement interior featuring a large metal furnace unit, exposed ceiling joists, concrete walls, and scattered boxes and cables on the floor.

A high-efficiency gas furnace would save about $110 a year to run in Johnson County compared with a gas furnace.

  • A high-efficiency gas furnace$530 a year
  • A gas furnace$640 a year

Estimates for a typical Johnson County home, from EIA household energy data, Kansas fuel prices and NOAA climate normals. Your home will differ.

In Kansas, HVAC licensing for homes is left to the counties and cities.

Johnson County sets its own rule for who can do this work, since Kansas leaves it to the county and the city rather than a state board. Whether a contractor needs a local license here, and what that license takes, depends on where the house sits inside the county. That is different from a state license, where one board tests and records every contractor in the state. Here the record, if there is one, is kept locally.

For a furnace install, the protection that matters most comes from the permit, not a license. Most cities and counties require a permit for a furnace replacement and an inspection once the work is done, and that inspection is what checks the gas connection and venting, the part of the job where a mistake is dangerous. Most homes in Johnson County heat with gas, so that inspection is doing real work on jobs like this one.

Source: Kansas Office of Revisor of Statutes

What size furnace does my house need?
The right size comes from a load calculation, not the square footage of your house. A contractor measures your insulation, your windows, your ceiling height, and how much air leaks in and out, then works out how much heat you actually lose on a cold night. A furnace that's too big will short cycle, switching on and off before it warms the house evenly. One that's too small will run constantly and still lose ground on the coldest nights, and here that means nights averaging 23°F. Ask the contractor for the load calculation, not just a number based on your old furnace.
How do I know it's time to replace my furnace?
An aging furnace that needs repairs more often is the clearest sign, especially if the same part keeps failing or a repair costs a large share of what a new furnace would. Uneven heat, a furnace that runs longer than it used to, or a yellow flame instead of blue are also reasons to have it looked at. Homes here need heat from October through April, seven months a year, so a furnace that's struggling in the fall is worth replacing before the cold months, not during them. A contractor can tell you whether what you're seeing is normal wear or a sign the furnace is done.
Is a high-efficiency furnace worth it?
It depends on how much you'll run the furnace and what you're replacing. Every non-weatherized gas furnace made since November 2015 has to reach at least 80 percent AFUE, so even a standard new furnace wastes less gas than an older one might. A high-efficiency furnace pulls more heat out of the same amount of gas than that minimum, and the difference adds up over a heating season that runs seven months here, October through April. Most homes in this area heat with gas, so the choice mainly comes down to the difference in upfront cost against how much gas you'd save over the years you own the furnace. A contractor can walk through the actual models and price that tradeoff for your house.