HVAC Repair in Wichita, KS
Homes here need heat from October through April and cooling from May through September. If your system quits, tell us what it's doing and a licensed contractor who covers Sedgwick County will get in touch.
Tell us about the job
It takes about a minute.
Sedgwick County runs its system nearly year round
Your furnace and your AC don't get much rest here. Heat runs October through April, then cooling takes over for May through September, so there's almost no month where something isn't kicking on. Winter nights averaging 24°F mean the burner cycles on and off for hours at a stretch, and each start puts wear on the igniter and the flame sensor. Summer afternoons near 90°F push the compressor hard for five straight months, and that's when a weak capacitor or a low refrigerant charge finally gives out.
The grid here doesn't always hold up its end. Nearly one in five Kansas households lost power for a full day or more in 2024, and the county has logged 332 damaging wind events and 11 winter storms over the past ten years. A furnace or AC that was already struggling often shows it right after the power comes back on.
- 7 months
- October through April, your system heats
- 5 months
- May through September, it cools
- 24°F
- the average winter night it heats against
- 90°F
- the average summer afternoon it cools against

NOAA nClimDiv, 1991–2020 normals
A new furnace and air conditioner would cut about $150 a year off heating and cooling for a typical Sedgwick County home.
Estimates for a typical Sedgwick County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Kansas fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed.
Replacement makes sense when the furnace's heat exchanger is cracked, the air conditioner's compressor has failed, or repairs keep coming.
In Kansas, HVAC licensing for homes is left to the counties and cities.
Source: Kansas Office of Revisor of Statutes
- Why is my heat not working?
- Most of the time it comes down to power, gas, or airflow. Check that the thermostat is set to heat and a few degrees above room temperature, and that the furnace switch and breaker are on. If you have a gas furnace, check that the gas valve is open and the pilot or igniter is doing its job, you may hear the igniter click or see a small flame through the sight glass. A dirty filter can also cut off airflow enough to trip a safety switch and shut the whole system down. At 24 degrees on a winter night here, this is not one to leave for morning. If the basics check out and it still will not fire, a contractor needs to look at the ignition system or the control board.
- Why is my system running but not cooling the house?
- The system is on, but something between the coil and the vents is not doing its job. Start with the filter, a clogged one starves the coil of airflow and can freeze it solid. Next check the outdoor unit, the fan should be spinning and the coil should be clear of grass clippings or leaves. If the filter is clean and the outdoor unit is running but the air from the vents is barely cool, the refrigerant charge is probably low, and that is a job for a contractor with gauges, not something to chase down yourself.
- What can I check before calling for HVAC repair?
- Check the thermostat first, the batteries, the mode, and the set temperature. Then check the filter, pull it out and hold it up to a light, if you cannot see through it, replace it. Look at the breaker panel for a tripped breaker, and if you have a gas furnace or water heater, check that the gas valve is open. For outdoor units, clear away any leaves, grass, or debris piled against the coil. If you have done all this and the system still is not working right, tell the contractor what you checked, it saves them time on the visit.


