HVAC Installation in Andover, KS
A new system here will heat from October through April and cool from May through September every year. Tell us about the house, and a licensed contractor who covers Butler County will get in touch.
Tell us about the job
It takes about a minute.
A new system in Andover has two seasons to answer for
Winter nights here average 24°F from December through February, and a new furnace has to hold a house steady against that from October through April. That is seven months of the year it runs. Summer afternoons average 89°F, and the same system has to bring that down for five months straight, May through September. Between the two, there is no real off season. Something is asking for heat or cooling all twelve months.
55.7% of homes here heat with gas, and any new furnace installed today has to meet the federal minimum efficiency rating. Wind is the bigger risk to plan around. Butler County has logged 190 damaging wind events over the past ten years, and outages follow storms like that. In Kansas, 19% of households went at least 24 hours without power in 2024, which matters most for how a new system starts back up once the power does.
- 7 months
- October through April, your system heats
- 5 months
- May through September, it cools
- 24°F
- the average winter night it heats against
- 89°F
- the average summer afternoon it cools against

NOAA nClimDiv, 1991–2020 normals
In Kansas, HVAC licensing for homes is left to the counties and cities.
Butler County sets its own rule on who can do HVAC work, since Kansas leaves that decision to counties and cities. That means whether a contractor needs a local license or registration depends on whether Butler County or the city inside it has set up that kind of rule, and there's no state record to check either way.
For a new heating and cooling system, what protects you here is the permit process. In most cities and counties, installing a furnace, air conditioner or heat pump needs a permit from the local building office, and the finished work gets inspected before it's signed off. That inspection is what catches a bad gas connection or a system put in wrong, not a state license, because Kansas doesn't issue one.
Source: Kansas Office of Revisor of Statutes
- When should I replace my HVAC system?
- Look at the age and how often it breaks down. A furnace or air conditioner that needs a repair every year is a better candidate for replacement than one that has been reliable. If your furnace fails during the winter here, with nights averaging 24°F from December through February, that is not the time to gamble on one more season. A contractor can look at the unit and tell you whether it is worth fixing again or worth replacing.
- Should I replace my furnace and air conditioner at the same time?
- If both are old, replacing them together often makes sense, but it depends on the condition of each one. Homes here run the furnace October through April and the air conditioner May through September, so both units work hard all year. A furnace and air conditioner installed at different times can still be matched by a contractor, so a working unit does not have to be replaced just because the other failed. Have a contractor check both and tell you honestly which one still has life left.
- What happens during an HVAC installation?
- A contractor removes the old equipment, sets the new furnace, air conditioner or heat pump in place, and connects it to the ducts, gas or electrical lines, and condensate drain as needed. They check the refrigerant charge on an air conditioner or heat pump, test the ignition and heat exchanger on a furnace, and run the system through a full cycle before leaving. In most cities and counties here, this work needs a permit from the local building office and an inspection once it is done. Ask the contractor whether they are pulling the permit or if that falls to you.

