Kansas HVAC Pros
A snow-covered two-story house at night with one illuminated upper window, surrounded by bare trees and snow-dusted evergreen shrubs.

Furnace Installation in Andover, KS

A new furnace here will run from October through April every year. Tell us about the house, and a licensed contractor who covers Butler County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
An unfinished concrete basement containing a metal HVAC air handler, exposed wooden ceiling joists with sheet-metal ducts, a hanging bare bulb, copper pipes, and stacked cardboard boxes.

Seven months of heat, and nights near 24°F

Andover needs a furnace from October through April. That's seven months of the year the system has to work, not just the coldest stretch of winter. Winter nights here average 24°F, so the furnace is running through the long, cold part of the night as much as the day.

55.7% of homes in the area heat with gas, and any new gas furnace installed now has to reach at least 80.0 percent AFUE, the federal minimum for non-weatherized models. Storms are part of the picture too. The area has seen 8 winter storms and 190 damaging wind events over the past ten years, the kind of weather that knocks out power. In 2024, 19% of Kansas households went at least 24 hours without electricity. A furnace that starts back up on its own once power returns matters here.

7 months
October through April, your furnace is on duty
24°F
the average winter night it heats against
56%
of homes here heat with gas, so most furnaces here burn gas
80% AFUE
the federal minimum any new unit must meet
Isometric cutaway illustration of a house showing interior rooms with furniture, a furnace unit with a tall flue pipe outside, and ductwork running through the attic.
Your furnace works hardest from November through March.

NOAA nClimDiv, 1991–2020 normals

A bare concrete basement containing a gray gas furnace with metal ductwork and a vertical flue pipe, lit by a single hanging bulb.

A high-efficiency gas furnace would save about $110 a year to run in Butler County compared with a gas furnace.

  • A high-efficiency gas furnace$490 a year
  • A gas furnace$600 a year

Estimates for a typical Butler County home, from EIA household energy data, Kansas fuel prices and NOAA climate normals. Your home will differ.

In Kansas, HVAC licensing for homes is left to the counties and cities.

Butler County is not one of the places that licenses HVAC contractors itself, so whatever rule applies here comes from the county or city, not the state. There is no state exam behind the work and no state record to check.

What covers you here is the permit and inspection a furnace replacement needs from the local building office in most Kansas cities and counties. The building office signs off on the installation and inspects it once the work is done, which is what catches a bad gas connection before it becomes a problem. In Butler County, 55.7% of homes heat with gas, so that inspection is doing real work on jobs like this one.

Source: Kansas Office of Revisor of Statutes

What size furnace does my house need?
The right size comes from a load calculation, not the size of your old furnace or your square footage alone. A contractor measures your walls, windows, insulation and ceiling height and runs the numbers, because a furnace that's too big will short cycle and one that's too small will run constantly and still leave rooms cold. With winter lows here averaging 24°F, that calculation matters even more than it would somewhere milder. Ask for the load calculation in writing before you agree to a size.
How do I know it's time to replace my furnace?
If your furnace is struggling to keep up, cycling on and off more than it used to, or needs a repair that costs a large share of a new unit, replacement is worth considering. Age matters too. Furnaces here run seven months a year, October through April, so the wear adds up faster than in places with a shorter heating season. A furnace that can't hold your home at temperature on a 24°F night is telling you something. A contractor can look at its condition and tell you whether repair still makes sense or whether you're past that point.
Is a high-efficiency furnace worth it?
It depends on how much you run your furnace and what you're comparing it to. Every furnace sold new today has to meet at least 80 percent AFUE, so the question is really whether to go higher than that. With heat needed seven months of the year here, a furnace that runs that long has more hours to make efficiency count than one that sits idle most of the year. A contractor can walk you through the models available and what each one means for your specific house.