Furnace Repair in Andover, KS
Furnaces here run from October through April. If yours quits, tell us what it's doing and a licensed contractor who covers Butler County will get in touch.
Tell us about the job
It takes about a minute.
Seven months of Andover winters wear on a furnace
Your furnace runs from October through April here. On the coldest nights, with lows near 24°F, it lights and shuts off over and over to keep the house warm. Each of those cycles puts a load on the igniter and the burner. That is usually what gives out first, a furnace that will not light, or one that lights and then quits.
Butler County has had 190 damaging wind events and 8 winter storms over the past ten years, and plenty of Kansas households lost power for a day or more in 2024. Most furnaces come back on by themselves once power is restored. If yours does not, that is worth having looked at rather than waiting out.
- 7 months
- October through April, your furnace is on duty
- 24°F
- the average winter night it heats against
- 56%
- of homes here heat with gas, so most furnaces here burn gas
- 8 winter storms
- in ten years, the nights a failure hurts most

NOAA nClimDiv, 1991–2020 normals
A new furnace would cut about $130 a year off heating for a typical Butler County home.
Estimates for a typical Butler County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Kansas fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed and the heat exchanger is sound.
Replacement makes sense when the heat exchanger is cracked or the furnace keeps needing parts.
In Kansas, HVAC licensing for homes is left to the counties and cities.
Kansas itself keeps no record of who is qualified to repair your furnace. Whatever rule applies comes from Butler County or the city within it, not from the state, so what's required depends on the exact address of the house.
With gas furnace repair, the part that matters most is the gas connection itself, since a bad joint is what makes the job dangerous. Whether that connection gets checked by anyone depends on Butler County or your city, because Kansas has no state license to require it. In Butler County, 55.7% of homes heat with gas, so this kind of repair comes up often here.
Source: Kansas Office of Revisor of Statutes
- Why won't my furnace turn on?
- Most often the thermostat isn't calling for heat the way it should, or power to the furnace has been interrupted. Check that the thermostat is set below room temperature and has working batteries if it uses them. Next check the furnace switch, which looks like a light switch near the unit, and the breaker at the panel. If those are fine, the igniter or flame sensor may have failed, and that needs a contractor to test and replace.
- Why is my furnace blowing cold air?
- Air blows before the burners light and after they shut off, so a few minutes of cool air at the start and end of a cycle is normal. If it runs cold the whole time, the igniter may not be lighting the burners, or the flame sensor may be shutting the burners off right after. A dirty filter can also choke airflow enough to trip a safety switch and stop the burners while the fan keeps running. A contractor can tell which of these it is.
- Why won't my furnace pilot light stay lit?
- A pilot light that won't stay lit usually means the thermocouple has worn out and can no longer hold the gas valve open. It can also mean a draft is blowing the flame out, or the pilot orifice is partly clogged. A standing pilot uses no electricity, so a power outage isn't the cause. With winter lows here averaging 24°F, a furnace that won't hold a pilot needs attention quickly, and a contractor can test the thermocouple and replace it if that's the problem.


