Furnace Repair in Arkansas City, KS
Furnaces here run from October through April. If yours quits, tell us what it's doing and a licensed contractor who covers Cowley County will get in touch.
Tell us about the job
It takes about a minute.
Seven months of heat puts real wear on your furnace
From October through April your furnace is the machine keeping your house livable. Winter nights average 25°F here, so on the coldest stretches the burner is cycling on and off most of the day to hold the temperature. Each cycle means the igniter has to light the burner again, and that part wears a little more every time. A weak igniter eventually stops lighting it at all, and the house goes cold with the blower still running air that never gets warm.
Cowley County has seen 8 winter storms and 123 damaging wind events over the past ten years, and outages follow storms like these. A furnace needs power to run even when it burns gas, since the control board and blower depend on it. In Kansas, 19% of households went at least 24 hours without power in 2024. Most furnaces come back on by themselves once power returns, but it is worth checking the thermostat if the house stays cold after an outage.
- 7 months
- October through April, your furnace is on duty
- 25°F
- the average winter night it heats against
- 60%
- of homes here heat with gas, so most furnaces here burn gas
- 8 winter storms
- in ten years, the nights a failure hurts most

NOAA nClimDiv, 1991–2020 normals
A new furnace would cut about $110 a year off heating for a typical Cowley County home.
Estimates for a typical Cowley County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Kansas fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed and the heat exchanger is sound.
Replacement makes sense when the heat exchanger is cracked or the furnace keeps needing parts.
In Kansas, HVAC licensing for homes is left to the counties and cities.
Kansas does not issue a state HVAC license, so whether Cowley County or a city inside it requires one for furnace work depends on the local rule where the house sits, not on any statewide test or record.
A furnace repair comes down to the gas connection, since that is the part that can hurt someone if it is done wrong. Whether anyone checks that connection here depends on Cowley County's own rule, because Kansas has none. In Cowley County, 60.2% of homes heat with gas, so that connection is doing real work in most houses here.
Source: Kansas Office of Revisor of Statutes
- Why won't my furnace turn on?
- Most of the time it's the thermostat, the power supply, or the gas supply, and a contractor checks those in that order. If the thermostat screen is blank, check the batteries first. If it has power but the furnace still won't start, the door panel might be loose, since most furnaces have a safety switch that keeps the burners off unless that panel is seated right. Past that, it could be the igniter, a blown fuse on the control board, or the gas valve, and those need a contractor to test.
- Why is my furnace blowing cold air?
- Check the thermostat fan setting first. If it's set to "on" instead of "auto", the blower runs all the time, even between heating cycles when the air hasn't been warmed yet. If it's already set to "auto" and you're still getting cold air, the furnace may be failing to ignite the burners even though the blower still runs. That points to the igniter, the flame sensor, or the gas supply, and it's worth having someone look at it soon since a furnace that runs the blower without heating isn't doing its job for the 7 months a year homes here need it.
- Why won't my furnace pilot light stay lit?
- This usually means the thermocouple has worn out. That's the small part that sits in the pilot flame and tells the gas valve it's safe to keep sending gas. Once it wears out, it stops reading the flame right and shuts the gas off even though the pilot is lit. A draft blowing out the pilot or a dirty pilot orifice can also cause it, but a thermocouple is the most common reason, and a contractor can replace it directly.


