Kansas HVAC Pros
A bare branch covered in dripping icicles photographed during a winter ice storm, with snow-covered shrubs and a house visible in the background.

HVAC Installation in Salina, KS

A new system here will heat from October through April and cool from May through September every year. Tell us about the house, and a licensed contractor who covers Saline County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
An unfinished basement featuring exposed ceiling joists, a metal HVAC unit with round ductwork, a hanging light bulb, and scattered boxes and debris along the left wall.

A new system here works almost year round

Salina asks a lot of a heating and cooling system. Winters bring nights averaging 22°F from December through February, and summers push afternoons to 90°F. Add it up and homes here need heat or cooling all twelve months, with only short stretches in between where the system gets a break.

A new furnace or heat pump has to be sized for those 22°F nights, and the air conditioner or heat pump has to handle those 90°F afternoons without struggling. Wind is part of the picture too. Saline County has seen 102 damaging wind events over the past ten years, and 13 winter storms in that same stretch. Whatever gets installed needs to keep running through both.

7 months
October through April, your system heats
5 months
May through September, it cools
22°F
the average winter night it heats against
90°F
the average summer afternoon it cools against
Isometric line illustration of a cutaway single-story house showing interior rooms with furniture, ceiling ductwork, a chimney flue, and a furnace unit outside the exterior wall.
Your system heats October through April and cools May through September.

NOAA nClimDiv, 1991–2020 normals

In Kansas, HVAC licensing for homes is left to the counties and cities.

Saline County or the city the house sits in sets the rule for this job, since Kansas leaves HVAC licensing to them. Some cities and counties license or register HVAC contractors on their own. Others have no rule at all. There is no state test or state record behind any of it, only whatever the local office decides to require.

What stands in for that here is the permit process. Installing a furnace, air conditioner or heat pump in most cities and counties needs a permit from the local building office, and the finished job gets an inspection when the work is done. That is not a license, but it is the check most homeowners in Kansas actually get.

Source: Kansas Office of Revisor of Statutes

When should I replace my HVAC system?
Once your furnace or air conditioner is old and repairs keep coming back, replacement usually makes more sense than another fix. A contractor can tell you how much life is left in the unit based on its condition, not just its age. Here that decision matters more, since your furnace runs October through April and your air conditioner runs May through September, which is the whole year with no real break. If a repair costs a large share of what a new system would, or the breakdowns are getting more frequent, replacing it is the better move.
Should I replace my furnace and air conditioner at the same time?
If both are old, replacing them together is often worth considering, but it isn't required. A furnace and air conditioner installed at different times can still work fine side by side, as long as the parts a contractor matches, like the coil and the blower, are sized correctly for each other. Where replacing them together helps most is if your furnace and air conditioner are close in age, since one failing usually means the other isn't far behind. Winter lows here average 22°F and summer highs average 90°F, so whichever system goes down, you don't want to be without it for long. A contractor can look at the age and condition of both and tell you whether pairing the work makes sense for your house.
What happens during an HVAC installation?
A contractor removes the old furnace, air conditioner or heat pump and sets the new equipment in its place, then connects it to your ductwork, gas line or refrigerant lines, and electrical. After that they test it, checking airflow, refrigerant charge, and that the thermostat is talking to the system correctly. In most cities and counties, this work needs a permit from the local building office, and an inspector checks the job once it's done. That inspection is there for your protection, confirming the gas and electrical connections are safe before you're relying on the system through a Kansas winter or summer.