HVAC Repair in Salina, KS
Homes here need heat from October through April and cooling from May through September. If your system quits, tell us what it's doing and a licensed contractor who covers Saline County will get in touch.
Tell us about the job
It takes about a minute.
Salina asks a lot of your system, in both directions
Your furnace runs October through April here, and winter nights average 22°F through the coldest stretch of the year. That means long hours of the burner cycling on and off, night after night, to keep up. Each start puts wear on the igniter and the ignition system, and a worn igniter is a common reason a furnace stops lighting on a cold morning.
Then summer flips the load the other way. Afternoons average 90°F for five months, May through September, and the air conditioner runs hard to keep pace. That kind of steady demand wears on the compressor and can leave a system short on cooling when you need it most. On top of the wear from daily use, this part of Kansas sees real storm activity, 102 damaging wind events and 13 winter storms over the last ten years, and Kansas households saw power outages of 24 hours or more not long ago. A furnace or air conditioner that loses power and comes back on can trip a fault that needs a technician to clear.
- 7 months
- October through April, your system heats
- 5 months
- May through September, it cools
- 22°F
- the average winter night it heats against
- 90°F
- the average summer afternoon it cools against

NOAA nClimDiv, 1991–2020 normals
A new furnace and air conditioner would cut about $150 a year off heating and cooling for a typical Saline County home.
Estimates for a typical Saline County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Kansas fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed.
Replacement makes sense when the furnace's heat exchanger is cracked, the air conditioner's compressor has failed, or repairs keep coming.
In Kansas, HVAC licensing for homes is left to the counties and cities.
Saline County sets its own rule for who can do this work, and whether a license is required comes down to whether the county or the city where the house sits has set up that kind of licensing. Kansas does not run a state exam or keep a state record of HVAC contractors, so there is no statewide credential to check. A contractor working here may be licensed by the county, licensed by a city, or working under no local license at all if neither has set one up.
For a heating and cooling repair, the gas side is the part that matters most if it is done wrong, since a bad connection is a leak risk. Whether a license covers that work here depends entirely on what Saline County or its cities have set up, since Kansas leaves it to them. Where neither has set a rule, no license applies to the job at all.
Source: Kansas Office of Revisor of Statutes
- Why is my heat not working?
- Start with the thermostat and the power to the furnace. If the thermostat screen is blank, check the breaker and the furnace switch, which usually looks like a light switch near the unit. A pilot light or igniter that won't stay lit points to a flame sensor or ignition problem, and that's a repair for a licensed contractor. With winter nights here averaging 22°F, a furnace that's short cycling or blowing cold air needs attention the same day, not next week.
- Why is my system running but not cooling the house?
- The most common cause is a dirty filter or a frozen coil, both of which choke off airflow. Check the filter first and replace it if it's gray or clogged. If the outdoor unit's fan is spinning but the air inside still feels warm, the refrigerant charge or the compressor could be the issue, and that needs a licensed contractor to diagnose. On a 90°F afternoon, a system that runs constantly without cooling is working hard for nothing, so it's worth shutting off and having someone look at it rather than letting it run.
- What can I check before calling for HVAC repair?
- Check the thermostat batteries and settings first, since a dead battery or a setting left on the wrong mode causes more no-heat and no-cool calls than people expect. Next check the breaker panel and any power switch near the furnace or outdoor unit. Look at the air filter and swap it if it's dirty. If the outdoor unit is covered in leaves or debris, clear around it. After a storm, especially with how often wind and ice hit around here, check for anything that fell on or near the outdoor unit before assuming the system itself failed.


