Kansas HVAC Pros
A brushed-metal rain shower head spraying hot water, surrounded by thick steam.

Water Heater Repair in Great Bend, KS

Tell us what your water heater is doing, and a licensed contractor who covers Barton County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
A brushed nickel kitchen faucet dispensing hot water into a stainless steel sink, surrounded by rising steam.

Cold winters and storm outages both work against your water heater here

Barton County winters push nights down to an average of 21°F from December through February. That cold reaches the water coming into your water heater, and the burner or heating element has to run longer to bring it up to temperature. That extra runtime wears on the thermostat and the heating element or burner assembly sooner than it would in a milder place.

Wind is the other problem. The area has logged 126 damaging wind events over the past ten years, and in 2024 a lot of Kansas households lost power for a full day or more. When the power drops, an electric water heater stops heating until it comes back, and most units start up again on their own once it does. A gas water heater with a standing pilot keeps running through the outage, but if a storm blows the pilot out, hot water will not show up again until someone relights it.

21°F
the average winter night, and colder incoming water means longer heating
7 months
October through April, the months homes here need heat
19%
of Kansas households lost power for a day or more in 2024, and a heater with an electric element or electric ignition stops without it
Isometric cutaway illustration of a small single-storey house with a dark tiled gable roof, showing interior rooms with a bathtub, toilet, sinks, beds and a cylindrical water heater tank with a flue pipe running through the roof.
Your water heater works hardest from November through March.

NOAA nClimDiv, 1991–2020 normals

A brushed nickel rain shower head sprays streams of hot water while steam rises against a gray tiled wall.

A new water heater would cut about $60 a year off hot water for a typical Kansas home.

  • A heat pump water heater$130 a year
  • A new high-efficiency gas water heater$160 a year
  • An older gas water heater$220 a year

Estimates for a typical Kansas home, compared with an older unit built to the federal minimum, from EIA household energy data and Kansas fuel prices. Your home will differ.

Repair makes sense when an element, thermostat or gas valve has failed.

Replacement makes sense when the tank itself is leaking.

Why is my water heater leaking from the bottom?
Most likely the tank itself has rusted through from the inside and is starting to fail. Sediment and water sit at the bottom of the tank for years, and once corrosion opens a hole in the steel, no fitting or valve can stop it. It could also be a loose drain valve or a pipe fitting, which a contractor can tighten or replace. But if the water is coming from the tank itself, the water heater needs to be replaced, not repaired.
Why won't the pilot light on my water heater stay lit?
A weak or dirty thermocouple is the most common reason. That's the small sensor that sits in the pilot flame and tells the gas valve it is safe to keep the gas flowing. When it wears out or gets coated with residue, it stops sensing the flame properly and shuts the gas off, even though the pilot lit fine a moment ago. A dirty pilot orifice or a draft in the area can also blow the flame out. A contractor can clean or replace the thermocouple, which usually solves it.
Can a tankless water heater be repaired?
Yes, most tankless water heater problems can be fixed without replacing the whole unit. Common issues are a fouled heat exchanger from mineral buildup, a failed igniter, or an error code pointing to a sensor or flow problem. A contractor can flush the unit, clean or replace the affected part, and get it running again. Replacement is usually only needed when the heat exchanger itself has cracked or corroded through.