HVAC Repair in Great Bend, KS
Homes here need heat from October through April and cooling from June through September. If your system quits, tell us what it's doing and a licensed contractor who covers Barton County will get in touch.
Tell us about the job
It takes about a minute.
Eleven months of work, most winters below freezing
Your furnace runs October through April here, and your air conditioner picks up June through September. That is 11 months a year one system or the other is working, with almost no break between them.
Winter nights average 21°F from December through February, cold enough that the burner cycles on and off many times a night to hold the house steady. Each start puts a little more wear on the igniter, and a worn one stops lighting the burner at all, which shows up as a house that will not warm up. Summer afternoons average 90°F, and that kind of heat load runs the compressor hard for four straight months. Barton County has also seen 126 damaging wind events and 10 winter storms over the past ten years, and with almost a fifth of Kansas households losing power for a day or more in 2024, a system that was already struggling has that much less room to recover once the power comes back on.
- 7 months
- October through April, your system heats
- 4 months
- June through September, it cools
- 21°F
- the average winter night it heats against
- 90°F
- the average summer afternoon it cools against

NOAA nClimDiv, 1991–2020 normals
A new furnace and air conditioner would cut about $160 a year off heating and cooling for a typical Barton County home.
Estimates for a typical Barton County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Kansas fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed.
Replacement makes sense when the furnace's heat exchanger is cracked, the air conditioner's compressor has failed, or repairs keep coming.
In Kansas, HVAC licensing for homes is left to the counties and cities.
Kansas leaves HVAC licensing to the counties and cities, so whether this repair requires a license comes down to whatever rule Barton County and its cities have set, not anything the state tracks. There is no state license or registry behind the work here.
Without a state license standing behind the job, the protection here depends on whatever Barton County requires, if anything. This repair involves a gas connection on the heating side, and that connection is the part that has to be right, since a bad one is a safety risk. Whether it gets checked comes down to Barton County's own rules, since the state does not set that here.
Source: Kansas Office of Revisor of Statutes
- Why is my heat not working?
- The most common reason is a bad igniter, a dirty flame sensor, or a thermostat set wrong. Gas furnaces need the igniter to glow hot enough to light the burners, and a cracked or weakened igniter won't get there. If the flame sensor is coated with residue, the furnace can light and then shut itself off within seconds because it can't confirm a flame. Check that the thermostat is set to heat and the temperature is above room temperature before assuming the worst. At 21°F on a winter night here, a furnace that won't stay lit needs attention fast.
- Why is my system running but not cooling the house?
- If the blower is running but the air isn't cold, the most likely causes are a dirty air filter, a frozen evaporator coil, or low refrigerant from a leak. A clogged filter starves the system of airflow, and that can freeze the coil, which then blocks cold air from moving through the ducts at all. A refrigerant leak won't fix itself and will keep the system running without actually cooling. With afternoons here reaching 90°F, a system that's only moving warm air needs a contractor to check the coil and refrigerant charge.
- What can I check before calling for HVAC repair?
- Start with the thermostat. Make sure it's set to the right mode, the temperature is set correctly, and the batteries aren't dead. Next, check the air filter. A filter that's clogged with dust can choke off airflow and cause problems that look like a bigger issue than they are. Check the breaker panel too, since a tripped breaker will stop a furnace or air conditioner cold and is easy to miss. Kansas sees its share of power interruptions, and most systems will restart on their own once power is back, but a tripped breaker often needs to be reset by hand. If none of that explains what's wrong, a contractor will need to look at it directly.


