Furnace Installation in Great Bend, KS
A new furnace here will run from October through April every year. Tell us about the house, and a licensed contractor who covers Barton County will get in touch.
Tell us about the job
It takes about a minute.
Seven months of heat, and winters that average 21°F
Great Bend homes need the furnace running from October through April, seven months out of the year. Winter nights average 21°F, so the furnace is not running lightly during that stretch. A new furnace here has to be sized and installed for that kind of cold, not just an occasional cold snap.
Most homes in the area heat with gas, and any non-weatherized gas furnace built on or after November 19, 2015 has to reach at least 80 percent AFUE by federal rule. Barton County has also seen its share of winter storms and damaging wind over the past ten years, and close to a fifth of Kansas households went at least 24 hours without power in 2024. Worth keeping in mind when you're deciding how your new furnace should be set up.
- 7 months
- October through April, your furnace is on duty
- 21°F
- the average winter night it heats against
- 69%
- of homes here heat with gas, so most furnaces here burn gas
- 80% AFUE
- the federal minimum any new unit must meet

NOAA nClimDiv, 1991–2020 normals
A high-efficiency gas furnace would save about $110 a year to run in Barton County compared with a gas furnace.
Estimates for a typical Barton County home, from EIA household energy data, Kansas fuel prices and NOAA climate normals. Your home will differ.
In Kansas, HVAC licensing for homes is left to the counties and cities.
Barton County sets its own rule on who can do HVAC work, since Kansas leaves that to the counties and cities. That means whether a contractor needs a local license depends on the county's own rules, not a state board or a state exam. There is no state record of who is qualified to install a furnace here.
What stands between you and bad work on this job is the permit and inspection most cities and counties require for a furnace replacement. The building office checks that the venting and gas connection were done right, since that is the part of the job that can go wrong in a dangerous way. Gas heat is how most homes in Barton County stay warm, so that inspection is doing real work here.
Source: Kansas Office of Revisor of Statutes
- What size furnace does my house need?
- It depends on your home's square footage, ceiling height, insulation, window count, and layout, so there's no single number that fits every house. A contractor works this out with a load calculation, not a chart based on square footage alone. Going by size alone leads to a furnace that's too big or too small, and either way you end up with uneven heat and a shorter equipment life. With winter lows here averaging 21°F, getting this number right matters more than it would somewhere milder.
- How do I know it's time to replace my furnace?
- Watch for a furnace that struggles to keep up on the coldest nights, cycles on and off more than it used to, or needs a repair call more than once a season. Rising gas bills with no other explanation point the same direction. An older furnace nearing the end of its working life is a candidate for replacement rather than another repair, especially if the repairs keep coming. Since homes here need heat from October through April, seven months of the year, a furnace on its last legs has more chances to fail when you need it most.
- Is a high-efficiency furnace worth it?
- A high-efficiency furnace burns less gas to make the same heat, and with 68.7% of homes in Barton County heating with gas, that difference shows up on a lot of bills here. Every non-weatherized gas furnace built since November 2015 has to reach at least 80 percent AFUE, so even a standard model today is more efficient than older units. High-efficiency furnaces go further than that minimum. Whether the higher upfront cost makes sense for your house depends on your current furnace's age and condition, and a contractor can walk you through that for your specific situation.


