Furnace Repair in McPherson, KS
Furnaces here run from October through April. If yours quits, tell us what it's doing and a licensed contractor who covers McPherson County will get in touch.
Tell us about the job
It takes about a minute.
Seven months of Kansas cold takes a toll on your furnace
McPherson County homes run the furnace from October through April, seven months of the year. Winter nights average 23°F from December through February, and on those nights the burner lights and shuts off again and again. Each start puts wear on the igniter and the parts that get the burner lit.
Most homes here heat with gas, so when the igniter or the flame sensor gives out, the burner will not light and the house goes cold. The area has seen 15 winter storms and 115 damaging wind events over the past ten years, and in 2024, 19% of Kansas households lost power for at least 24 hours. When the power drops in the middle of a cold snap, a furnace that was already working hard has one more reason to quit.
- 7 months
- October through April, your furnace is on duty
- 23°F
- the average winter night it heats against
- 58%
- of homes here heat with gas, so most furnaces here burn gas
- 15 winter storms
- in ten years, the nights a failure hurts most

NOAA nClimDiv, 1991–2020 normals
A new furnace would cut about $120 a year off heating for a typical McPherson County home.
Estimates for a typical McPherson County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Kansas fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed and the heat exchanger is sound.
Replacement makes sense when the heat exchanger is cracked or the furnace keeps needing parts.
In Kansas, HVAC licensing for homes is left to the counties and cities.
McPherson County sets its own rule for who can do this work, since Kansas leaves the decision to local government rather than a state board. There is no statewide test or license number tied to a contractor's name here. What applies, if anything, depends on what the county or any city inside it has put in place.
A furnace repair that involves the gas line is the part worth taking seriously, because a loose or bad connection is what makes this job dangerous rather than just technical. Whether anyone checks that connection here comes down to what McPherson County has set up on its own, since no state license stands behind the work. Almost 6 in 10 homes in the county heat with gas, so this is the kind of repair where that connection matters most.
Source: Kansas Office of Revisor of Statutes
- Why won't my furnace turn on?
- Most of the time it's the thermostat, a tripped breaker, or a safety switch that's stopped the furnace before it starts. Check that the thermostat is set below room temperature and has power, then check the breaker panel. Furnaces also have a switch that looks like a light switch near the unit, sometimes it gets bumped off. If those are fine and it still won't start, the igniter or a flame sensor may have failed, and that needs a contractor to check.
- Why is my furnace blowing cold air?
- If air is moving but it's not warm, the furnace may be running the blower without the burners lighting. That points to an ignition problem or a safety switch shutting off the burners while the fan keeps going. It can also mean the thermostat fan setting is on "on" instead of "auto," which pushes air through the ducts even when the furnace isn't heating. Check that setting first, since it's the one thing you can fix yourself.
- Why won't my furnace pilot light stay lit?
- A pilot light that won't stay lit is usually the thermocouple, the small sensor that tells the gas valve the flame is burning. When it wears out or sits out of place, it shuts the gas off even though the pilot is lit. A draft blowing out the flame is possible too, but if it keeps happening, the thermocouple is the more likely cause. Either way, this is a gas part, so have a contractor check it rather than relighting it repeatedly.


