Kansas HVAC Pros
A snow-covered driveway and yard viewed from inside through a white window frame during a winter snowstorm.

Furnace Repair in Hutchinson, KS

Furnaces here run from October through April. If yours quits, tell us what it's doing and a licensed contractor who covers Reno County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
An unfinished concrete basement containing a gas furnace with sheet-metal ductwork, utility shelving, and exposed overhead joists.

Seven months of Hutchinson winter wears a furnace down

Your furnace works from October through April here, seven months of the year. On nights that average 23°F, it cycles on and off for hours at a time, and every one of those starts puts wear on the igniter and the ignition control board.

Most Reno County homes heat with gas, so when the igniter fails or the board stops sending power to it, the burner will not light at all. Wind is part of the picture too. The area has logged 141 damaging wind events over the past ten years, and wind that strong can push back on a furnace's vent, which trips the pressure switch and shuts the system down until a contractor resets it.

7 months
October through April, your furnace is on duty
23°F
the average winter night it heats against
65%
of homes here heat with gas, so most furnaces here burn gas
10 winter storms
in ten years, the nights a failure hurts most
Isometric line illustration of a cutaway single-story house showing interior rooms with furniture, a furnace unit with a tall flue pipe, and connected ductwork running under the pitched roof.
Your furnace works hardest from November through March.

NOAA nClimDiv, 1991–2020 normals

An unfinished basement containing a gray HVAC furnace with ductwork, exposed wooden joists, a concrete floor, and miscellaneous clutter in one corner.

A new furnace would cut about $130 a year off heating for a typical Reno County home.

  • A new high-efficiency furnace$500 a year
  • An older furnace$630 a year

Estimates for a typical Reno County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Kansas fuel prices and NOAA climate normals. Your home will differ.

Repair makes sense when one part has failed and the heat exchanger is sound.

Replacement makes sense when the heat exchanger is cracked or the furnace keeps needing parts.

In Kansas, HVAC licensing for homes is left to the counties and cities.

Kansas has no state HVAC license. Whether a contractor is licensed at all depends on the county or city the house sits in, since Reno County and any city inside it can set their own rule or set none. There is no state record to point to either way.

For a furnace repair, the part that matters most is the gas connection, since that is what makes the job dangerous if it is done wrong. Where Reno County or its cities license the trade, that license is what stands behind the work. Where they do not, the facts here do not name anything that checks that connection in its place. About 65.1% of homes in Reno County heat with gas, so this is the kind of repair done often in this county.

Source: Kansas Office of Revisor of Statutes

Why won't my furnace turn on?
Most often the thermostat isn't calling for heat the way it should, or power isn't reaching the furnace. Check that the thermostat is set below room temperature and has working batteries if it uses them. Check the furnace switch, which looks like a light switch near the unit, and check the breaker. If those are fine, the igniter or a safety switch inside the furnace may have failed, and that calls for a contractor to test.
Why is my furnace blowing cold air?
If air is moving but it's not warm, the furnace may be running on fan only, or it may have shut off its burners while the blower keeps going. Check the thermostat fan setting is on auto, not on. If that's not it, a dirty flame sensor or a clogged filter can cause the burners to shut off shortly after starting, so the fan finishes out blowing air that never got heated. A contractor can tell you which it is.
Why won't my furnace pilot light stay lit?
A pilot light that won't stay lit usually means the thermocouple has worn out, since that's the part that senses the flame and keeps the gas valve open. Drafts or a dirty pilot opening can also blow it out or block it. Relighting it yourself only works if the problem is temporary. If it goes out again, a contractor should look at the thermocouple and the gas valve rather than relighting it repeatedly.