Water Heater Repair in Newton, KS
Tell us what your water heater is doing, and a licensed contractor who covers Harvey County will get in touch.
Tell us about the job
It takes about a minute.
Storms and outages are what put a water heater out in Newton
Harvey County has logged 91 damaging wind events and 9 winter storms over the past ten years. Storms like that knock out power, and in Kansas, 19% of households went at least 24 hours without it in 2024.
A gas water heater with a standing pilot keeps heating through an outage since the pilot doesn't run on electricity. One with an electronic ignition will not restart on its own, even after the power comes back on. If your water heater stopped working around the time of a storm, that is worth checking first.
- 23°F
- the average winter night, and colder incoming water means longer heating
- 7 months
- October through April, the months homes here need heat
- 19%
- of Kansas households lost power for a day or more in 2024, and a heater with an electric element or electric ignition stops without it

NOAA nClimDiv, 1991–2020 normals
A new water heater would cut about $60 a year off hot water for a typical Kansas home.
Estimates for a typical Kansas home, compared with an older unit built to the federal minimum, from EIA household energy data and Kansas fuel prices. Your home will differ.
Repair makes sense when an element, thermostat or gas valve has failed.
Replacement makes sense when the tank itself is leaking.
- Why is my water heater leaking from the bottom?
- The most common cause is the tank itself rusting through from the inside and starting to fail. Sediment builds up at the bottom of the tank over years, and it traps water against the steel until it corrodes a hole. A leak can also come from a loose drain valve or a fitting that has worked itself loose, which a contractor can tighten or replace. If the tank itself is leaking, it needs to be replaced, since there is no way to patch a hole in the steel.
- Why won't the pilot light on my water heater stay lit?
- Most of the time this means the thermocouple has worn out and can no longer sense that the pilot is burning, so it shuts the gas off. A dirty pilot orifice or a draft in the area can also blow the flame out or keep it too weak to hold. Sometimes the problem is a failing gas control valve, which is a different repair than replacing the thermocouple. A contractor can test which part is at fault rather than guessing and replacing parts one at a time.
- Can a tankless water heater be repaired?
- Yes, most tankless water heater problems are repairs, not replacements. A heat exchanger that scales up from hard water, a flow sensor that fails, or an igniter that stops working can all be serviced without replacing the unit. Error codes on the display usually point a contractor straight to the part that needs attention. Full replacement is only needed when the heat exchanger itself has cracked or corroded through.


