Kansas HVAC Pros
A snow-covered two-story shingled house at night with one illuminated upstairs window, surrounded by snow-laden trees under a dark blue sky.

HVAC Repair in Dodge City, KS

Homes here need heat from October through April and cooling from June through September. If your system quits, tell us what it's doing and a licensed contractor who covers Ford County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
A gray forced-air furnace with sheet-metal ductwork stands in an unfinished basement with exposed wooden joists, concrete walls, and a hanging incandescent bulb.

Eleven months of work, every year

Your furnace runs from October through April here, and on winter nights that average 21°F it cycles on and off most of the night to keep up. That kind of run time wears on the igniter and the flame sensor, and when one of them finally quits, the house goes cold instead of warm. Come summer the air conditioner takes over for four more months, working against afternoons near 90°F. The compressor and the fan motor carry that load, and a system already worn thin from winter has little left to give when the heat sets in.

Ford County also sees its share of rough weather, with 37 winter storms and 251 damaging wind events over the past ten years. Wind can knock loose an outdoor unit's wiring or connections, and a power outage after a storm will take a furnace down too, since the blower and controls need electricity to run even on gas heat. Most systems come back on their own once power returns, but if yours doesn't, that's a sign something needs a closer look.

7 months
October through April, your system heats
4 months
June through September, it cools
21°F
the average winter night it heats against
90°F
the average summer afternoon it cools against
Isometric cutaway illustration of a small single-story house showing a furnace with a flue pipe through the roof and ducting running to rooms containing a sofa, chair and bed.
Your system heats October through April and cools June through September.

NOAA nClimDiv, 1991–2020 normals

An unfinished basement featuring concrete block walls, exposed floor joists, and a metal forced-air furnace with ductwork near a central pillar.

A new furnace and air conditioner would cut about $150 a year off heating and cooling for a typical Ford County home.

  • A new furnace and AC$850 a year
  • An older furnace and AC$1,000 a year

Estimates for a typical Ford County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Kansas fuel prices and NOAA climate normals. Your home will differ.

Repair makes sense when one part has failed.

Replacement makes sense when the furnace's heat exchanger is cracked, the air conditioner's compressor has failed, or repairs keep coming.

In Kansas, HVAC licensing for homes is left to the counties and cities.

Source: Kansas Office of Revisor of Statutes

Why is my heat not working?
Most often the thermostat, the igniter, or the flame sensor. Gas furnaces need power, gas, and a spark or hot surface to light the burners, and a failure in any one of those stops the whole cycle. Check first whether the thermostat is set to heat and calling for it, and whether the breaker or the furnace switch has power. With nights averaging 21°F here in the winter, a furnace that will not light needs a contractor out the same day.
Why is my system running but not cooling the house?
The blower may be running while the compressor outside is not, which means air moves through the house but none of it is cold. This can come from a tripped breaker at the outdoor unit, a clogged filter that starves the system of airflow, or low refrigerant from a leak. A dirty filter is worth checking yourself first since it takes a minute and costs nothing. Anything past that, especially refrigerant, needs a licensed contractor.
What can I check before calling for HVAC repair?
Start with the filter. A filter clogged with dust chokes airflow and can make a furnace or air conditioner struggle or shut off on its own. Check that the thermostat has power and is set correctly, and check the breaker or furnace switch. If the outdoor unit is not running at all, make sure nothing is blocking it and that it has power. Beyond these, the diagnosis needs a contractor who can test the system directly.