Kansas HVAC Pros
A snow-covered two-story house at night during a snowstorm, with one illuminated upstairs window glowing against the dark blue sky.

HVAC Installation in Hays, KS

A new system here will heat from October through April and cool from June through September every year. Tell us about the house, and a licensed contractor who covers Ellis County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
A gray forced-air furnace with sheet-metal ductwork stands in an unfinished basement with exposed wooden joists, concrete walls, and a hanging incandescent bulb.

Eleven months of the year, your system is working

Hays gets a real break from heating or cooling one month a year. Winter nights average 20°F from December through February, and a furnace has to hold that line from October through April, seven months straight. Come summer, afternoons average 90°F and the air conditioner takes over for June through September. A new system here needs to be sized for both jobs, not just one.

Any furnace or air conditioner installed today has to meet the federal minimum efficiency rating, and in a climate that runs a system this many months, that rating matters more than it would somewhere milder. The area also sees its share of rough weather, with 29 winter storms and 136 damaging wind events recorded over the past ten years. In Kansas, 19% of households went at least 24 hours without power in 2024, so it is worth knowing how a new system will come back on once the power does.

7 months
October through April, your system heats
4 months
June through September, it cools
20°F
the average winter night it heats against
90°F
the average summer afternoon it cools against
Isometric cutaway illustration of a single-story house showing a gray furnace connected to white ductwork and a flue pipe extending through the shingled roof, with simplified furniture in the interior rooms.
Your system heats October through April and cools June through September.

NOAA nClimDiv, 1991–2020 normals

In Kansas, HVAC licensing for homes is left to the counties and cities.

Kansas leaves HVAC licensing to the cities and counties, so what stands behind a contractor's name here depends on Ellis County's own rule rather than any state exam or state list. Kansas keeps neither.

For a job like this, installing a furnace and air conditioner, the protection most often comes from the local building office. In most cities and counties, an installation like this needs a permit and an inspection once the work is done, and that inspection is what checks the gas and electrical connections before the system runs.

Source: Kansas Office of Revisor of Statutes

When should I replace my HVAC system?
Replace it when repairs stop making sense, or when the system can't keep up with a 20 degree night or a 90 degree afternoon here. A furnace or air conditioner that's calling for a repair more than once a season is telling you it's near the end. Age matters too, but the pattern of breakdowns matters more than the number on the nameplate. A contractor can look at the actual unit and tell you whether it's worth fixing again or worth replacing.
Should I replace my furnace and air conditioner at the same time?
If they're close in age, it usually makes sense to do both together. Homes here run the furnace from October through April and the air conditioner from June through September, so both pieces of equipment see real work most of the year and tend to wear out on a similar timeline. Replacing them together also means the furnace and air conditioner are matched to run as one system, rather than pairing new equipment with an old unit it wasn't built to work with. If one unit is much newer than the other, a contractor can tell you whether it's worth keeping for now.
What happens during an HVAC installation?
A contractor removes the old furnace or air conditioner, or both, and sets the new equipment in its place, connecting it to the existing ducts, gas line or electrical circuit, and refrigerant lines. They'll check that the ductwork and the new unit's capacity match the house, since equipment that's too big or too small for the home won't heat or cool it evenly. Most cities and counties around here require a permit for this work and an inspection once it's done. The contractor handles that permit as part of the job.