Furnace Repair in Pittsburg, KS
Furnaces here run from October through April. If yours quits, tell us what it's doing and a licensed contractor who covers Crawford County will get in touch.
Tell us about the job
It takes about a minute.
Seven months of Crawford County winters wear on a furnace
Your furnace has to run October through April here, seven months of the year. On nights that average 26°F, it is cycling on and off for hours at a stretch, and every cycle puts a little more wear on the igniter and the burner. That is usually where trouble shows up first, as a furnace that will not light or shuts off partway through a cycle.
Crawford County has also logged 84 damaging wind events and 5 winter storms over the past ten years, and close to a fifth of Kansas households lost power for at least a day in 2024. When the power drops in the middle of a cold snap and comes back on, most furnaces restart on their own, but if yours does not fire back up, that is worth a call.
- 7 months
- October through April, your furnace is on duty
- 26°F
- the average winter night it heats against
- 59%
- of homes here heat with gas, so most furnaces here burn gas
- 5 winter storms
- in ten years, the nights a failure hurts most

NOAA nClimDiv, 1991–2020 normals
A new furnace would cut about $110 a year off heating for a typical Crawford County home.
Estimates for a typical Crawford County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Kansas fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed and the heat exchanger is sound.
Replacement makes sense when the heat exchanger is cracked or the furnace keeps needing parts.
In Kansas, HVAC licensing for homes is left to the counties and cities.
Crawford County sets its own rule on who can do this work, separate from anything the state requires. Kansas does not test or license HVAC contractors itself, so there is no state record to check. Whatever licensing applies here comes from the county or the city where the house sits, not from Topeka.
A furnace repair means someone is working on a gas connection, and that is the part of the job where a mistake actually hurts someone. Almost 6 in 10 homes in Crawford County heat with gas, so this is common work here. Whether that connection gets inspected after the repair depends on what the county or city requires, since Kansas leaves that decision to them as well.
Source: Kansas Office of Revisor of Statutes
- Why won't my furnace turn on?
- Start with the thermostat. Check that it's set to heat and the temperature is set above room temperature, and check the batteries if it uses them. If the thermostat looks right, check the furnace switch, the one that looks like a light switch near the unit, and make sure the breaker hasn't tripped. Gas furnaces also need the gas valve open. If none of that gets it running, a contractor can find out whether the problem is the igniter, the flame sensor, or something electrical.
- Why is my furnace blowing cold air?
- If air is blowing but it's not warm, the furnace may be running the blower without firing up the burners. That can happen when the igniter fails, when the flame sensor is dirty, or when the gas supply is interrupted. A dirty filter can also choke off airflow enough to trip a safety switch that shuts down heating but leaves the fan running. Check the filter first. If it's clean and you still have cold air, it needs a contractor to check the ignition system.
- Why won't my furnace pilot light stay lit?
- This usually means the thermocouple has gone bad. That's the small part that sits in the pilot flame and tells the gas valve it's safe to stay open. When it wears out or gets out of position, the valve shuts the gas off as soon as you let go of it, even though the pilot lit fine a moment before. A draft blowing out the pilot is the other common cause. Either way, a contractor can tell which it is and replace the part if needed.


