Furnace Installation in Pittsburg, KS
A new furnace here will run from October through April every year. Tell us about the house, and a licensed contractor who covers Crawford County will get in touch.
Tell us about the job
It takes about a minute.
Seven months of heat, out of a furnace built to last longer than that
Pittsburg needs a furnace running from October through April. That is seven months out of the year, with winter nights averaging 26°F. A furnace here does not get an off season to rest and recover, it goes from fall straight into the coldest stretch and keeps going.
Crawford County has logged 5 winter storms and 84 damaging wind events over the past ten years, and close to a fifth of Kansas households lost power for a full day or more in 2024. When the power drops on a cold night, a new furnace needs to come back on by itself once it's restored. Any non-weatherized gas furnace installed today has to hit at least 80 percent AFUE, so the model going into your house is already built to that federal minimum.
- 7 months
- October through April, your furnace is on duty
- 26°F
- the average winter night it heats against
- 59%
- of homes here heat with gas, so most furnaces here burn gas
- 80% AFUE
- the federal minimum any new unit must meet

NOAA nClimDiv, 1991–2020 normals
A high-efficiency gas furnace would save about $100 a year to run in Crawford County compared with a gas furnace.
Estimates for a typical Crawford County home, from EIA household energy data, Kansas fuel prices and NOAA climate normals. Your home will differ.
In Kansas, HVAC licensing for homes is left to the counties and cities.
Crawford County does not run its own contractor license, and Kansas does not either, so there is no state or county record to check on whoever installs your furnace. Whatever protection you get here comes from somewhere other than a license.
For a furnace installation, that protection is the permit and inspection most local building offices require. The building office checks the work when it is done, including the gas connection, which is the part of the job that has to be right. With most homes in Crawford County heating with gas, that inspection is the step standing between you and a bad hookup.
Source: Kansas Office of Revisor of Statutes
- What size furnace does my house need?
- A contractor has to work this out with a load calculation, not a chart based on square footage. That calculation looks at how much heat your house loses through its walls, windows, attic, and ductwork, along with your local winter lows. Winter nights here average 26°F, so the furnace needs to hold that line all night, not just handle a mild evening. A furnace that is too big will short cycle and wear out faster, and one that is too small will run constantly from October through April and still leave the house cold. Get the calculation done for your specific house rather than going by the size of the old unit.
- How do I know it's time to replace my furnace?
- Age is one sign, along with how the furnace has been behaving. Watch for rooms that heat unevenly, a furnace that cycles on and off more than it used to, or a gas bill that keeps climbing without a clear reason. If a contractor has already repaired it more than once in a season, replacing it usually makes more sense than paying for another repair. With heat needed here from October through April, a furnace that struggles now will only get worse as the season goes on. A contractor can look at its age and condition and tell you where it stands.
- Is a high-efficiency furnace worth it?
- It depends on how long you plan to stay in the house and how much you use the furnace. Every non-weatherized gas furnace built since November 2015 has to reach at least 80 percent AFUE, so even a standard model today wastes less gas than older units. A high-efficiency furnace burns less gas than that to produce the same heat, which matters more here since homes need heat for 7 months out of the year. Crawford County runs mostly on gas heat, with 59.2 percent of homes using it, so the fuel savings apply to most of your neighbors too. A contractor can walk through the difference in equipment for your specific house.


